Filter
Top Products
23
Tuning in a radio station
OFF
ON
POWER
STANDBY/ON
BASS
TREBLE
C D
PHONES
DIMMER
TX-DS484
AV RECEIVER
AMFMDVD PHONO
1VIDEO
2VIDEO
TI
CH
INPUTMUL
TAPE
STANDBY
TUNING
CLEAR
MEMORY
FM
MODE
SPEAKERSA B LATE NIGHTSURROUND MODE
PARAMETER CONTROLLER
PARAMETER SELECTOR
PRESET
U
P
MASTER VOLUME
D
O
W
N
FM
AM
√ TUNING ®
FM MODE
1. Press the FM or AM button.
2. Use the TUNING √/® buttons to change the frequency.
® (up)..............the frequency increases.
√ (down).........the frequency decreases.
• The frequency changes in 50 kHz steps in FM and 10 kHz (or
9 kHz) in AM each time you press the TUNING √/® button.
• In FM, if this button is held continuously for more than 0.5 sec-
onds, the frequencies are scanned automatically (FM auto tun-
ing mode). When a broadcast is received, scanning stops.
When an RDS (Radio Data System) station broadcasting PS (Pro-
gram Service Name) information is received, the RDS indicator
lights up and the name of the station is displayed.
• RDS reception is only available on the European model, and
only in areas where RDS broadcasts are available.
When you tune in a stereo FM station, the FM STEREO indicator
lights up if the signal is sufficiently strong.
If the signal is weak, it may be impossible to tune in to the desired
station. In this case, tune in as follows.
Press the FM MODE button. The FM MUTE indicator turns off. At
this time, the station will be in mono and interstation noise will be
heard. Select the station to which you want to listen.
Manual tuning
Receiving RDS (European model only)
Listening to a stereo radio station (FM mode)
AMFM
TUNING
1
2
CLEAR
MEMORY
FM MODE