Filter
Top Products
16
Speaker setup
9. Press the PARAMETER SELECTOR® button to display
the LFE LEVEL parameter, and press the PARAMETER
CONTROLLER √/® buttons to set the value.
You can set the LFE LEVEL parameter for the Dolby digital or
DTS playback.
In general, leave this parameter to 0dB.
Pressing the PARAMETER CONTROLLER √/® buttons
repeatedly toggles the values. Display the desired value.
With the Dolby digital sound, the parameter value changes as
shown on the left. With the DTS sound, the parameter value
changes in the following order: +10dB, 0dB, –∞dB.
Also, refer to “LFE level attenuation” on page 22.
10. Press the PARAMETER SELECTOR ® button. The
POWER ON VOLUME ON/OFF parameter appears.
Press the PARAMETER CONTROLLER √/® buttons to
toggle between ON and OFF.
ON: Power On Volume function is enabled.
OFF: Power On Volume function is disabled.
Display the desired setting and press the PARAMETER
SELECTOR ® button.
Refer to page 18 for more information on the Power On Volume
function.
Note:
Even if the parameter has already been set to ON, turn it OFF,
then turn it ON again to enable the Power On Volume function.
Use the remote controller and produce the test tone to adjust the
level of the connected speakers.
1. Press the TEST TONE button.
Each speaker produces the test tone (pink noise) in the follow-
ing order:
2. To adjust the level of each speaker, press the CH SEL button
to select a speaker and press the LEVELπ/† buttons to
raise or lower the level.
The test tone should sound at the same level when you hear it in
your listening position. You can adjust the level in the range
between –12dB and +12dB.
3. Press the TEST TONE button to complete adjustment.
Test Tone (Remote controller only)
LEFT
L-SURROUND
CENTER RIGHT
R-SURROUNDSUBWOOFER
(Front L ch) (Center ch) (Front R ch)
(Subwoofer) (L-Surround) (R-Surround)
PARAMETER SELECTOR
PARAMETER CONTROLLER
PARAMETER SELECTOR
PARAMETER CONTROLLER
or
9
or
10
or
LEVEL
CH SEL
TEST
TONE
1, 3
2
TEST
TONE
This chart shows how the display changes when the PARAMETER SELECTOR buttons are pressed. Selecting a parameter and pressing the
PARAMETER CONTROLLER button will change the value or setting for the selected parameter.
Parameter selector
START
Subwoofer YES / NO
FRONT Speaker LARGE / SMALL
FRONT Speaker Distance
0.3 ~ 9m, 1 ~ 30ft
Center Speaker Distance
0.3 ~ 9m, 1 ~ 30ft
POWER ON VOLUME
ON / OFF
Surround Speaker Distance
0.3 ~ 9m, 1 ~ 30ft
QUIT
LFE Level Attenuator
Dolby Digital:
0dB / –10dB / –∞dB
DTS:
+10dB / 0dB / –∞dB
Center Speaker LARGE / SMALL / NONE
Surround Speaker LARGE / SMALL / NONE
PARAMETER SELECTORPARAMETER SELECTOR
10.