Filter
Top Products
12
Making antenna connections
Connecting the 300 ohm ribbon wire:
Loosen the screws and wrap the wire around these screws. Then
tighten the screws with a screwdriver.
Connecting the coaxial cable:
1. With your fingernail or a small screwdriver, press the stoppers
outward and remove the cover.
2. Remove the transformer wire A from slit B and insert it into slit
C.
3. Prepare the coaxial cable as shown in the diagram.
Connect the 75/300 ohm antenna adapter to the coaxial cable.
1 Insert the end of the cable.
2 Clamp it in place with pliers.
4. Re-install the cover.
Do not use the same antenna for both FM and TV (or VCR) recep-
tion since the FM and TV (or VCR) signals can interfere with each
other. If you must use a common FM/TV (or VCR) antenna, use a
directional linkage type splitter.
Assemble the loop antenna as shown in the illustration.
• Refer to the next page for details on connecting the AM loop
antenna.
1. Press down the lever.
2. Insert the wire into the hole.
3. Release the lever to replace it.
Connecting the antenna cable to the 75/300 ohm
antenna adapter (Worldwide models)
Directional Iinkage
Assembling the AM loop antenna
Connecting the antenna cable
12
Insert into the hole.
Directional linkage
type splitter
To TX-DS484 To TV (or VCR)
Outdoor
antenna
Indoor
antenna
300 ohms
ribbon wire
1
2
12 3
✦
✦
✦
✦
✦
✦
✦
✦
✦
✦
✦
6
mm
3
mm
6
mm
15mm
Slit C
Slit B
Wire A