Filter
Top Products
11
7. When the flashing channel is not the desired channel, turn the
PRESET/TUNING dial and select a different channel.
● If a station frequency has already been memorized in the
selected channel, the channel number will flash quickly.
● Each group contains ten channels.
● The channel can also be entered using the number buttons on the
remote control. If this is done, skip step 8.
8. Press the MEMORY button.
NOTE:
● 40 channels are available for storing preset stations.
1. Press the PRESET/TUNING button until Preset Mode is
selected.
With each press of the button, the mode changes one at a time in
the following sequence:
Continue pressing the PRESET/TUNING button until “PRESET”
appears on the display.
Skip this step if the remote control is used.
2. Use the GROUP button to select a group (A ~ D).
3. Use the PRESET/TUNING dial to select the desired channel.
To select a preset station using the remote control:
Press the PRESET a/b buttons.
To cancel a preset station:
1. Select the preset station as explained in the previous section.
2. While holding the MEMORY button, press the MODE button.
“--” will be shown on the MEMORY channel display.
1. Press the GROUP button, then select the group that you wish to
scan.
2. Press the SCAN button.
● The stations in the preset channels are played one after another
for a few seconds each. Once you have found a station that you
wish to continue listening to, press the SCAN button again to
stop scanning.
● If only one station has been stored in the selected group, the
channels are not scanned.
The part of the display that is lit up changes with each press of the
DIMMER button in the following sequence: Entire display lights up
→ Section [a] goes off → Section [b] also goes off → Entire display
goes off → Entire display lights up...
If the DIMMER button is pressed in stand-by mode:
In stand-by mode, each press of the DIMMER button changes the
time display to one of the four brightness levels.
Selecting a preset station
Scanning through the preset channels
(Preset Scan Tuning)
Using the DIMMER button
A
SIGNAL STRENGTH
ANTENNA
TUNED
STEREO
NARROW HI-BLEND AUTO
MEMORY
PRESET
PRESET / TUNING
or
Remote control
A
SIGNAL STRENGTH
ANTENNA
TUNED
STEREO
NARROW HI-BLEND AUTO
MEMORY
DIMMER MEMORY MODE
MEMORY
Remote control
or
7
8
PRESET
PRESET / TUNING
or
Remote control
A
SIGNAL STRENGTH
ANTENNA
TUNED
STEREO
NARROW
PRESET/
TUNING
DISPLAY GROUP SCAN
GROUP
or
Remote control
DIMMER MEMORY MODE
1
2
3
PRESET → TUNING → CHARACTER
SCAN
PLAY GROUP SCAN
Remote control
or
GROUP
DISPLAY GROUP SCAN
or
Remote control
1 2
TIMER
W.DAY
W.END
ONCE
SLEEP
A B TP TA
SIGNAL STRENGTH
ANTENNA RDS
TUNED
STEREO
MONO
NORMAL
NARROW HI-BLEND AUTO FINE MEMORY
MEMORY MODE
CLEAR
DIMMER
ab
c
DIMMER
or
Remote control