Filter
Top Products
27
SN 29343138 TX-L5.E
DISPLAYVIDEO
2
VIDEO
1
DVD/CD
DIMMER
HD TUNER
MD/TAPE
DVD MD
STANDBY
ON
MENU
TOP MENU
SETUP
SURR MODE
STEREO SP SETUP SW MODE
RETURN
P
R
E
S
E
T
PLAY
SLEEP
INPUT SELECTOR
DVD MD
Control
ENTER
DISPLAYVIDEO
2
VIDEO
1
DVD/CD
DIMMER
HD TUNER
MD/TAPE
DVD MD
STANDBY
ON
MENU
TOP MENU
SETUP
SURR MODE
STEREO SP SETUP SW MODE
RETURN
P
R
E
S
E
T
PLAY
SLEEP
INPUT SELECTOR
DVD MD
Control
ENTER
Operating the DVD player/CD player/MD recorder/Cassette Tape Deck With the
Supplied Remote Controller
■ To operate the Onkyo DVD player/CD player
First, connect the DVD player or CD player to the AV Receiver
with the z cable (see page 18).
When the CD player is connected to the DVD/CD jacks,
switch the source (see below).
Point the remote controller toward
the AV Receiver when you
want to operate this equipment.
Press DVD first.
■ To operate the Onkyo MD recorder/cassette
tape deck
First, connect the MD recorder or cassette tape deck to the AV
Receiver with the z cable (see page 18).
When the cassette tape deck is connected to the MD/TAPE
jacks, switch the source (see below).
Point the remote controller toward the AV Receiver when you
want to operate this equipment.
Press MD first.
Play
Play
Play
Down/Up
––
Fast Reverse/
Fast Forward
Rewind/
Fast Forward
Stop/Cancel
Stop
Pause
Reverse play
Upper: MD recorder
Lower: Cassette tape deck
Down/Up
Top menu
(DVD only)
Enter
(DVD only)
Menu
(DVD only)
Setup
(DVD only)
5/∞/2/3
(DVD only)
Return
(DVD only)
Pause
Stop
DVD
MD
■ Switch the source from MD to TAPE/Switch the source from DVD to CD
You can set the AV receiver to show “TAPE” when the MD/
TAPE source is selected by pressing MD/TAPE on the remote
controller or turning the INPUT dial on the unit. In the same
way, you can set the AV receiver to show “CD” when the DVD/
CD source is selected.
This setting is needed to make the z system control
effective among the Onkyo cassette tape deck, MD recorder,
DVD player and CD player.
To switch the source from MD to TAPE (or from DVD to
CD)
1 Press MD/TAPE (or DVD/CD) to select the input source.
2 Press and hold MD/TAPE (or DVD/CD) on the remote
controller until the display changes (for about 2 seconds).
To restore the display
Press and hold MD/TAPE (or DVD/CD) on the remote
controller until the display changes (for about 2 seconds).
Fast Reverse/
Fast Forward
DISPLAYVIDEO
2
VIDEO
1
DVD/CD
DIMMER
HD TUNER
MD/TAPE
DVD MD
STANDBY
ON
MENU
TOP MENU
SETUP
SURR MODE
STEREO SP SETUP SW MODE
RETURN
P
R
E
S
E
T
PLAY
SLEEP
INPUT SELECTOR
DVD MD
Control
ENTER
DVD/CD
MD/TAPE
ex