Filter
Top Products
23
SN 29343138 TX-L5.E
There are two ways to select radio stations:
• Manual tuning
• Presetting radio stations then selecting the preset
channels
Listening to the Radio
Tuning Manually
Turn INPUT dial to select the band
(FM or AM).
e.g. When FM is selected.
Turn VOLUME dial to adjust the
volume.
Press and hold TUNING/PRESET
™/£ for about 1.5 seconds.
When the band is FM
Auto tuning starts. The frequency changes in
50 kHz steps.
When a broadcast is received, scanning stops
and the frequency flashes in the display.
When the band is AM
The frequency changes as follows:
– (USA and Canadian models)
In 10 kHz steps
– (Other models)
In 9 kHz steps
When you release the button, the frequency
stops changing and flashes in the display.
Note
If you press and hold TUNING/PRESET ™/£
short time, the AV receiver enters the selecting
preset stations mode. Refer to “Selecting
Preset Stations” on page 24.
1
2
Appears when a broadcast is received.
4
■ Tuning in a weak frequency (only for FM
stations)
When you tune in a stereo FM station, the FM STEREO
indicator lights up if the signal is sufficiently strong.
If the signal is weak, you may not be able to tune to the
station. In this case, press FM MODE. The FM MUTE
indicator goes off.
Then select the station to which you want to listen.
(At this time, the station will be in mono and interstation noise
will be heard.)
INPUT
VOLUME
TUNING/PRESET
TUNING/PRESET
FM MODE
3
■ Receiving RDS (European models only)
When an Radio Data System (RDS) station broadcasting
Program Service Name (PS) information is received, the RDS
indicator lights up and the name of the station is displayed.
• RDS reception is only available on the European models,
and only in areas where RDS broadcasts are available.
While the frequency is flashing (for
about 3 seconds), press TUNING/
PRESET ™/£ to change the
frequency.
• The frequency changes each time you
press TUNING/PRESET ™/£.
• You can change the frequency as long
as the frequency in the display is
flashing. Each press of either button
causes the frequency to flash for about
3 seconds.
The corresponding indicator
is lit while the input source
is FM or AM.
VOLUME
dial
INPUT dial
SUBWOOFER MODE
SURROUND STEREO
ON
STANDBY
POWER
STANDBY
/
ON
ON
OFF
PHONES
ACOUSTIC
CONTROL
TUNING/PRESET
DVD
/
C
D
VIDEO
1
VIDEO
2
HD MD
/
TAPE
FM AM
INPUT
VOLUME
AV RECEIVER
TX
-
L
5
MEMORY
FM MODE
TUNING/PRESET ™/£
FM MODE
RDS