Filter
Top Products
63
Controlling Other Components
—Continued
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via , use
the following remote control codes:
•[DVD] REMOTE MODE button
0627:
Onkyo DVD player without (default)
• [CD/MD/CDR/DOCK] REMOTE MODE button
1817:
Onkyo CD player without (default)
0868:
Onkyo MD recorder without
1323:
Onkyo CD recorder without
2990:
Onkyo RI Dock without
Note:
If you connect an -capable Onkyo MD recorder, CD
recorder, or RI Dock component to the TAPE IN/OUT or
CBL/SAT jacks, for remote operation to work properly,
you must set the Input Display to MD, CDR, or DOCK
(see page 41).
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Onkyo
Components Connected via
1
Make sure the Onkyo component is con-
nected with an cable and an analog
audio cable (RCA).
See page 35 for details.
2
Enter the appropriate remote control code
for the [DVD] or [CD] REMOTE MODE but-
ton.
[DVD] REMOTE MODE button
1612:
Onkyo DVD player with
[CD/MD/CDR/DOCK] REMOTE MODE button
1327:
Onkyo CD player with
1808:
Onkyo MD recorder with
1322:
Onkyo CD recorder with
1993:
Onkyo RI Dock with
See the previous page for how to enter remote
control codes.
3
Press the [DVD] or [CD] REMOTE MODE
button, point the remote controller at the
AV receiver, and operate the component.
Resetting REMOTE MODE Buttons
1
While holding down the REMOTE
MODE button that you want to
reset, press the [L NIGHT] button
for 3 seconds.
The REMOTE MODE button lights up.
2
Press the REMOTE MODE button
again.
The REMOTE MODE button flashes
twice, indicating that it’s been reset.
The [DVD] and [CD] REMOTE
MODE buttons are preprogrammed
with remote control codes for control-
ling Onkyo DVD players and CD play-
ers respectively. When these buttons
are reset, the preprogrammed code is
restored.
Resetting the Remote Controller
1
While holding down the
[RECEIVER] REMOTE MODE but-
ton, press the [L NIGHT] button
for 3 seconds.
The [RECEIVER] button lights up.
2
Press the [RECEIVER] REMOTE
MODE button again.
The [RECEIVER] button flashes twice,
indicating that it’s been reset.
M
D/CDR
DOCK
CABLE
REMOTE MODE
SAT
VCR
TV
DVD
C
D
L NIGHT
M
D/CDR
DOCK
CABLE
REMOTE MODE
SAT
VCR
TV
DVD
C
D
RECEIVER
L NIGHT
RECEIVER