Onkyo HT-SR800 Stereo System User Manual


 
38
First Time Setup
—Continued
Using Audyssey 2EQ/HTIB
Notes:
When the automatic speaker setup is complete, the
Equalizer Settings (page 60) will be set to “Audyssey.”
•You can cancel the automatic speaker setup at any
point in this procedure simply by disconnecting the
setup microphone.
1
Turn on the AV receiver.
2
Put the speaker setup microphone at
measurement point
1
(page 37), and
connect it to the SETUP MIC jack.
Notes:
Make sure the microphone is horizontal.
If there’s an obstacle between the micro-
phone and any speaker, the automatic setup
will not work correctly. Set up the room as
you would when enjoying a DVD.
Positioning the microphone close to where
your ears would normally be will provide
better results. You can adjust the height of the
microphone by using a tripod or level table.
3
Press [ENTER].
The automatic speaker setup starts.
A test tone is output by each speaker in turn, as
the Audyssey 2EQ/HTIB function determines
which speakers are connected. This takes a few
minutes.
Note:
If any extraneous noise is picked up by the
microphone, the automatic setup may not
work correctly, so don’t make any noise.
MASTER VOLUME
VIDEO
STANDBY
TONE DISPLAYSTEREO DIMMERMEMORY
DIGITAL INPUT
TUNING MODE
ABSPEAKERS
TUNERTAPE
AUXCBL/SATVCR/DVR
DVD
MULTI CH C
D
SETUP ENTER
SETUP MIC
RETURN
CLEAR
LISTENING MODE
AUDIOLR
AUX INPUT
STANDBY/ON
PHONES
TUNING
PRESET
SETUP MIC
1
2, 6
SETUP MIC
4
When the following display appears,
move the speaker setup microphone to
measurement point
2
(page 37), and
then press [ENTER].
Audyssey 2EQ/HTIB performs more measure-
ments.
This takes a few minutes.
5
When the following display appears,
move the speaker setup microphone to
measurement point
3
(page 37), and
then press [ENTER].
Audyssey 2EQ/HTIB performs more measure-
ments.
This takes a few minutes.
When the measurements are complete, the
results are calculated and saved automatically.
6
When the automatic speaker setup is
complete, disconnect the speaker setup
microphone.
Notes:
If the AV receiver was previously muted, it will
be unmuted.
•Automatic speaker setup cannot be performed
while a pair of headphones is connected.
It takes about 10 minutes to complete the auto-
matic speaker setup.