Onkyo HT-SR800 Stereo System User Manual


 
59
Advanced Setup
—Continued
Notes:
The Center and Subwoofer distances can be set up to
5 ft. (1.5 m) more or less than the Front distance. For
example, if the Front distance is set to 20 ft. (6 m), the
Center and Subwoofer distances can be set between 15
and 25 ft. (4.5 and 7.5 m).
The Surround and Surround Back distances can be set
up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less than the
Front distance. For example, if the Front distance is set
to 20 ft. (6 m), the SurrRight, Surr Left, Surr Back R,
and Surr Back L distances can be set between 5 and 25
ft. (1.5 and 7.5 m).
The speaker distance cannot be adjusted while a pair
of headphones is connected, speaker set B is on, or the
multichannel DVD input is being used.
Speaker Levels
You can set the volume level of each speaker so that all
speakers can be heard equally at the listening position.
Notes:
•A quick way to adjust the speaker levels is to press the
remote controller’s [TEST TONE] button to turn on
the test tone, use the [LEVEL–] and [LEVEL+] but-
tons to adjust the levels, and use the [CH SEL] button
to select the speakers.
The speaker levels cannot be adjusted while a pair of
headphones is connected, speaker set B is on, or the
AV receiver is muted.
7
Press the [SETUP] button.
Setup closes.
1
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “Level Cal,” and
then press [ENTER].
A pink noise test tone is output by the
front left speaker.
SETUP
These settings are set automatically by the Automatic
Speaker Setup function (see page 37).
SETUP
RECEIVER
3
Turn up the volume so that you
can hear the test tone suffi-
ciently.
As each speaker outputs the test tone,
its name appears on the display.
4
Use the Left and Right [ ]/[ ]
buttons to adjust the speaker
level, and use the Down [ ] but-
ton to select the next speaker.
The levels can be adjusted from –12 to
+12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
5
Repeat step 4 so that the level of
the test tone coming from each
speaker is the same.
Speakers that you set to No or None in
the Speaker Configuration (page 56) do
not output the test tone.
6
Press the [SETUP] button.
Setup closes.
Don’t forget to turn down the volume if
you turned it up while setting the levels.
SETUP