Filter
Top Products
51
En
Controlling Other Components
You can use the AV receiver’s remote controller
(RC-764M) to control your other AV components. This
section explains how to enter the remote control code
(with the default underlined) for a component that you
want to control: DVD, TV, CD, etc.
The following REMOTE MODE are preprogrammed
with remote control codes for controlling the components
listed. You do not need to enter a remote control code to
control these components.
For details on controlling these components, see the pages
indicated.
You’ll need to enter a code for each component that you
want to control.
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via , use the
following remote control codes:
• BD/DVD
`30627:
Onkyo DVD player without
• TV/CD
`71817
:
Onkyo CD player without
`11807:
Onkyo TV
Preprogrammed Remote Control
Codes
BD/DVD
Onkyo Blu-ray Disc player (➔ 52)
TV/CD
Onkyo CD player (➔ 52)
PORT
Onkyo Universal Port Option (➔ 49)
Entering Remote Control Codes
1
Look up the appropriate remote control code in
the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down REMOTE MODE to which
you want to enter a code, press and hold down
DISPLAY until the remote indicator lights (about
3 seconds).
Note
• Remote control codes cannot be entered for RECEIVER
and ZONE 2.
• Only TV remote control codes can be entered for TV.
• Apart from RECEIVER, TV, and ZONE 2, remote con-
trol codes from any category can be entered for REMOTE
MODE. However, these buttons also work as input selec-
tor buttons (➔ 22), so choose a REMOTE MODE that
corresponds with the input to which you connect your
component. For example, if you connect your CD player
to the CD input, choose TV/CD when entering its remote
control code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered success-
fully, the remote indicator will flash once slowly.
Remote Control Codes for Onkyo
Components Connected via
1
Make sure the Onkyo component is connected
with an cable and an analog audio cable
(RCA).
See “Connecting Onkyo Components” for
details (➔ 18).
2
Enter the appropriate remote control code for
REMOTE MODE.
• BD/DVD
`31612:
Onkyo DVD player with
• TV/CD
`71327:
Onkyo CD player with
`42157:
Onkyo cassette tape deck with
• PORT
`81993:
Onkyo Dock
See the previous section for how to enter remote
control codes.
Note
• When using a cassette tape deck connected via , press
and hold TV/CD to switch to TAPE.
3
Press REMOTE MODE, point the remote control-
ler at the AV receiver, and operate the component.