Filter
Top Products
44
Basic Operations
Basic AV receiver Operation
1
Use the AV receiver’s input selector buttons to select an input
source.
To select an input source with the remote controller. Press the
[RECEIVER] button, and then press its INPUT SELECTOR buttons.
2
To turn the speakers on or off, use the AV receiver’s SPEAKERS
[A] and [B] buttons, or use the remote controller’s [SP A/B] button.
Pressing the remote controller’s [SP A/B] button cycles through the following
settings:
Speaker Set A→Speaker Set A&B→Speaker Set B→Off
Note that while speaker set B is on, speaker set A is reduced to 2.1-channel
playback.
See page 18 for more information about speaker sets A and B.
3
Start playback on the source component.
To watch a BD, DVD, or other video source, on your TV, select the video input
that’s connected to the AV receiver’s HDMI OUT, COMPONENT VIDEO
OUT, or MONITOR OUT.
On some DVD/BD players, you may need to change the digital or HDMI audio
output settings.
4
To adjust the volume, use the MASTER VOLUME control or the
remote controller’s VOL [ ]/[ ] button.
Since the AV receiver is designed for home theaters, it has a wide volume range
for precise adjustment. The volume can be set to Min, 1 through 79, or Max.
Note:
When the subwoofer volume level is set to a positive (+) value, the maximum
master volume level is reduced proportionally.
To set the level of the subwoofer, use the OUTPUT LEVEL control.
Because our ears are less sensitive to very low bass sounds, there’s a temptation
to set the level of the subwoofer too high. As a rule of thumb, set the subwoofer
level to what you think is the optimal level, and then back it off slightly.
5
Select a listening mode and enjoy!
See “Using the Listening Modes” on page 64.
VOL
RECEIVER
INPUT
SELECTOR
MASTER VOLUME SPEAKERS A/B
Input selector
OUTPUT LEVEL
MAX
MIN
Subwoofer’s
rear panel
OUTPUT
LEVEL
control
Remote
controller
AV receiver
Remote
controller
AV receiver
↑
Remote
controller
AV receiver
HT-S5200_En.book 44 ページ ２００９年３月９日 月曜日 午後４時３１分