Filter
Top Products
36
Connecting the AV receiver—Continued
■ If Your iPod Supports Video:
Connect your RI Dock’s audio output jacks to the
AV receiver’s CBL/SAT IN or VCR/DVR IN L/R
jacks, and connect its video output jack to the AV
receiver’s CBL/SAT IN or VCR/DVR IN V jack.
■ If Your iPod Doesn’t Support Video:
Connect your RI Dock’s audio output jacks to the
AV receiver’s TV/TAPE IN L/R jacks.
Notes:
• Do not connect components other than supplied UP-A1L dock with the PORT jack.
• While your iPod is seated in the Dock, its battery will be charged when the AV receiver is set to On or Standby.
• When UP-A1L is connected, the power consumption on standby mode slightly increases.
Connecting an RI Dock
Not all iPod models output video.
For information about which iPod models are supported
by the RI Dock, see the RI Dock’s instruction manual.
L
R
IN
CBL/SAT
V
CBL/SAT
L
R
IN
IN
VCR/DVR
VCR/DVR
V
V
CBL/SAT
IN
Connect one
or the other
L
R
IN
TV/TAPE
Notes:
• Enter the appropriate remote control code before using the AV receiver’s remote controller for the first time (see
page 78).
• Connect the RI Dock to the AV receiver with an cable (see page 37).
• Set the RI Dock’s RI MODE switch to “HDD” or “HDD/DOCK”.
• Set the AV receiver’s Input Display to “DOCK” (see page 43).
• See the RI Dock’s instruction manual for more information.
Connecting the Supplied UP-A1L Dock
HT-S5200_En.book 36 ページ ２００９年３月９日 月曜日 午後４時３１分