Filter
Top Products
11
Speakers
For detailed information, see the pages in parentheses.
A
STANDBY/ON indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
With the Auto Standby function, the SKW-460
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-460 automatically
enters Standby mode.
B
OUTPUT LEVEL control (40)
This control is used to adjust the volume of the sub-
woofer.
C
LINE INPUT (22)
This RCA input should be connected to the sub-
woofer pre out on the AV receiver with supplied
RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
the AV receiver (page 56).
Using the Floor Pads
If the subwoofer is placed on a hard
floor (wood, vinyl, tile, etc.) and
playback is very loud, the sub-
woofer's feet may damage the floor-
ing. To prevent this, place the
supplied pads underneath the sub-
woofer's feet. The pads also provide
a stable base for the subwoofer.
1
Keyhole slots
These keyhole slots can be used to wall-mount the
speaker. See page 23 for mounting instructions.
2
Speaker terminals
These push terminals are for connecting the speaker
to the TX-SR304 with the supplied speaker cables.
The supplied speaker cables are color-coded for
easy identification. Simply connect each cable to the
same-colored positive speaker terminal.
3
Speaker mount/bracket inserts
These threaded inserts can be used to attach the
speaker either horizontally or vertically to a speaker
mount or bracket.
Note:
Use commercially available 1/4" screws to attach
the speaker to a speaker mount or bracket.
Subwoofer (SKW-460)
1
23
■ Rear
To AC outlet
■ Front
Front, Center & Surround speakers (SKF-360F, SKC-360C, SKM-360S)
1
2
3
■ Rear