Filter
Top Products
18
Speaker setup
Front left
Front rightCenter
Surround left Surround right
You need to set up the speaker configuration for the speaker system
A (see page 12).
(There is no speaker configuration setup for the speaker system B.)
It is not necessary to set the parameters again once you have
completed the setup unless you change the speaker configuration.
Notes
• Speaker setup cannot be done if;
– Headphones are connected (see page 24),
– The speaker system B is on (see page 24), or
–“Multi ch” is selected with AUDIO SELECTOR button.
Speaker 5ch (Default)
Speaker 4ch
Speaker 3ch
Speaker 2ch
PRESET/ADJUST ™/£
SPEAKER ADJUST
Display and number of speaker channels
Notes
• The listening mode will automatically change according to the
number of channels if you set the number of channels.
• Speaker adjust mode will be cancelled if the next operation is
not performed within 8 seconds.
Setting the crossover frequency
To reproduce low frequencies between 60 Hz and 150 Hz in an
optimum condition, set the crossover frequency according to the
low-frequency reproduction capabilities of the subwoofer and
other speakers (front, center and surround).
Home theater in a box
It is not neccessary to change this setting when using the supplied
speaker system.
If you’re not using a subwoofer, bass sounds are output by the other
speakers and this setting has no effect.
1. Press SPEAKER ADJUST twice.
The current setting is displayed.
2. Press PRESET/ADJUST ™/£ repeatedly to
select the crossover frequency.
Select from 60, 80, 100, 120 and 150 Hz.
The following table lists the crossover frequency you should
choose depending on the diameter of your front speakers.
Front speaker diameter Crossover frequency
Larger than 8 inch (20 cm) 60 Hz
6.4 – 8 inch (16 – 20 cm) 80 Hz
5.2 – 6.4 inch (13 – 16 cm) 100 Hz
3.6 – 5.2 inch (9 – 13 cm) 120 Hz
Less than 3.6 inch (9 cm) 150 Hz
If you want more accurate setting, refer to the instruction
manuals of the speakers and perform the setting according to
their frequency response. Also listen to the actual sound and set
to the high position (120 or 150 Hz) if you feel that the sound
from the subwoofer is not enough or to the low position (60 or
80 Hz) if you feel that the sound is loud.
Selecting the number of speaker channels
1. Press SPEAKER ADJUST once.
When the button is pressed, the current speaker setup will be
displayed.
2. Press PRESET/ADJUST ™/£ repeatedly to
select the number of channels.