Filter
Top Products
13
Step 3:
Playing Back
6
Using the multi-zone function
You can listen to the sound in a separate room by making
the Zone connection (analog) between the unit and an
integrated amplifier placed in the separate room.
You can use a Blu-ray Disc player in the main room in
which the unit is placed, while receiving AM/FM broadcast
in the separate room. Audio can be played in the main
room and the separate room simultaneously, or only in the
separate room.
r The sources you can enjoy in the separate room are the
players connected to the analog audio input jacks of the
unit, and AM/FM broadcast.
r When listening to AM/FM broadcasting, you cannot
select different stations for the main room and separate
room. Therefore broadcasting of the same station will be
heard in the both rooms.
Connecting with Player
To use a Blu-ray Disc player or other players as the source
of Zone audio output, it is necessary to connect the RCA
audio output jacks of the player and the analog audio input
jacks of the unit using the analog audio (RCA) cable.
AUDIO
OUT
r
Zone audio output is not possible if the player and the unit
are connected only via HDMI cable or digital cable.
r
Some players require analog audio output setting.
Making multi-zone connection
Connect the ZONE 2 LINE OUT jacks of the unit and the
line-in jacks of the pre-main amplifier in a separate room
with an analog audio (RCA) cable.
Performing multi-zone playback
1.
Press ZONE2 on the remote controller, point the
remote controller at the remote controller sensor
and press
z
RECEIVER.
"Z2" lights on the unit and the ZONE function is enabled.
(ZONE 2 is now on.)
2.
Press ZONE2 on the remote controller again and
press INPUT SELECTOR of the input to be played in
a separate room.
To play the same source in the main room and separate
room, hold down ZONE2 for approximately 3 seconds.
The volume should be adjusted with the pre-main
amplifier used in the separate room.
To control on the main unit: Press ZONE2 and within
|UGEQPFURTGUUVJGKPRWVUGNGEVQTDWVVQPQHVJGKPRWVVQDG
played in a separate room. To play the same source in the
main room and separate room, press ZONE2 twice.
To turn off the multi-zone function: Press ZONE2 on the
remote controller and press
z
RECEIVER. Alternatively
press OFF on the main unit.
r Multi-zone playback cannot be performed if a player is
connected to HDMI jack using HDMI cable or OPTICAL/
COAXIAL jack using digital cable. Connect the players
using analog audio cable for multi-zone playback. Analog
audio output setting may be necessary on the player.
r If ZONE 2 is on, power consumption during standby
becomes larger than normal.
r While ZONE 2 is on, the RI linked system function
(interlink between Onkyo components) is disabled.