Filter
Top Products
31
En
You can temporarily mute the output of the integrated
amplifier.
Note
• While the integrated amplifier is muted:
– Adjusting the volume or setting the integrated amplifier to
Standby will unmute the integrated amplifier.
– Pressing INPUT / on the remote controller or turning the
INPUT selector on the integrated amplifier will display the
current input for 3 seconds.
•If MUTING is pressed while a setting is being performed, the
setup will be terminated.
• Even if the power cord is unplugged, the muting function will be
maintained on to the next session.
Tip
• If there’s a volume difference between your speakers and your
headphones, you can adjust the offset level (➔ page 37).
Note
• Always turn down the volume before connecting your
headphones.
• When headphones are connected, the balance adjustment and
SPEAKERS are disabled. Pressing the buttons will display the
message “PHONES”.
Muting the Sound
1
Press MUTING.
The message “MUTING” flashes on the information
display.
To unmute the integrated amplifier, press MUTING
again.
MUTING
Using Headphones
1
Connect a pair of stereo headphones with a
standard plug (1/4 inch or 6.3 mm) to the PHONES
jack.
When connecting the headphones, the message
“PHONES” appears on the information display and
the A/B LEDs go off.
You can adjust the volume and mute the sound, by
using VOLUME / .
While headphones are connected, no sound is output
from the speakers and PRE OUT jacks.
PHONES jack