Filter
Top Products
24
En
You can use the integrated amplifier’s pre-amp and main amp units individually (Split mode) to connect a sound
processor such as a graphic equalizer between the pre-amp and main amp units.
Note
• Depending on the sound processor used, noise may be produced upon switching the integrated amplifier on and off. In this case, turn
on each device in the following sequence: sound processor, integrated amplifier. Turn off each device in the following sequence:
integrated amplifier, sound processor.
Separating the Pre-amp and Main Amp Units
Important:
• Always turn the integrated amplifier off before connecting the MAIN IN jacks.
• To use this mode, you need to change the “ROUTE” setting (➔ page 39).
OUTPUT
L R
INPUT
L R
Integrated Amplifier A-9070
e.g., graphic equalizer