Filter
Top Products
12345678
O
N
12345678
O
N
12345678
O
N
Page 11
Switches 5 and 6 allow you to set a permanent EQ in
that particular zone. You can set that zone to have a
+4dB boost at 100Hz, a +4dB boost at 10kHz, a +4dB
boost at both frequencies, or a flat response (Fig. 10).
Fig. 10: Switches 5 & 6, Zone EQ Presets
+4dB Boost
at 100Hz
+4dB Boost
at 10kHz
+4dB Boost
at 100Hz and 10kHz
Flat Response
12345678
O
N
Switch 7 allows you to group multiple keypads so that
when a source is changed on one grouped keypad,
all other grouped keypads will also change. This is
handy for open floor plans where you might not want
different sources interfering with each other. Source
grouping is active when switch 7 is in the up position
(Fig. 11).
Fig. 11: Switch 7, Zone Grouping
Zone Group ON Zone Group OFF
12345678
O
N
Switch 8 allows you to have the volume reset itself to
a low level at power off. If this switch is in the up position,
the audio volume will reset to a preset low level when
power is restored to that zone. If the switch is in the
down position, then the audio volume will return to its
previous volume level when the zone was turned off
(Fig. 12).
Once the DIP switches for each zone are set, they
can be installed in most standard J-boxes (we
recommend the Slater model # S1-18-W), but not
all. The width of the keypad is 51mm or 2 inches. It
is important to make sure that the keypads are
compatible with the J-boxes being used in the
installation.
Fig. 12: Switch 8, Zone Volume Preset
Volume low-level preset
Set volume level
12345678
O
N
12345678
O
N
12345678
O
N