Filter
Top Products
IR EMITTER OUTPUTS
+12V OUTPUT PULSE
SUM
AUDIO OUTPUT
CONNECT TO NV-E6X
ODD NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)
EVEN NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)
Page 8
123456
Each piece of source equipment is connected to the E6M
amplifier with RCA cables. These go from the RCA output
on the back of the source equipment to the RCA source inputs
on the back of the E6M (Fig. 4).
Any unused inputs should
be shorted-circuited with the
supplied RCA shunts. This prevents any possibility of
crosstalk between the sources.
Fig. 4: Source Inputs
1
23456
INPUT SOURCES
L
R
IR commands are transferred from the E6M amplifier
to the source equipment via mini IR mouse emitters.
Four of these are supplied with your E Series system.
The emitters are plugged into the IR Emitter Outputs
(Fig. 5).
Outputs 1-6 are routed to the odd and even sources.
In other words, if source 1, 3, or 5 is selected at the
keypad, then emitters 1, 3, and 5 all flash, as does the
Sum output. If source 2, 4, or 6 is selected, then
emitters 2, 4, and 6 all flash, as does the Sum output.
IR source routing allows you to have two identical
sources and still have independent control of those two
sources.
If IR repeating is needed while the zone is turned
OFF, only the 1, 3, 5, and Sum outputs are
active.
Fig. 5: IR Emitter Outputs
The NV-VEC emitter flasher has an
adhesive pad that attaches directly
over the IR receiver window on the
source equipment.
RCA Shunts are provided with the E6M
and E6X packages and should be used
to short-circuit any unused source inputs.
IV. Attaching Source Equipment to the E6M
V. Connecting the IR Emitters