Filter
Top Products
VI. Connecting the E6M to the E6X
Page 9
* FOR SECOND KEYPAD
1000
0100
1100
0010
1010
1
2
3
4
5
00
01
10
11
B,T+4
100+4
10K+4
FLAT
0
1
ON
OFF
0
1
ON
OFF
SW #
1,2,3,4
ZN#
SRCE
GROUP
0110
1110
0001
1001
0101
1101
0011
1011
0111
1111
6
7
8
9
10
11
12
1*
2*
3*
SW 5-6 SETS ZONE EQ
SW 8 SETS VOLUME RESET
SW 7 SETS GROUP ON/OFF
SW 1-4 SETS ADDRESS
DIP SWITCH ARRAY
0
1
EXTERNAL
PROGRAMMER
VOL. RST.
@ ZN OFF
SW #
8
SW #
7
EQ
(DB)
SW #
5,6
Six additional zones can be added to the E6M. This is
accomplished by adding the E6X expander unit. The
connection is made by using the 37-pin Audiolink cable
and the 26-pin Datalink cable supplied with the E6X
package (Fig. 6).
No other cables are necessary except the AC power
cord. The speakers for the additional zones are attached
to the E6X in the same way as the E6M using the supplied
4-pin terminal block connectors.
Caution: Using more than one pair of 8-ohm speakers
per zone will damage the amplifier and void the
warranty.
Fig. 6: Audiolink and Datalink Connection
NV-AI2 Audiolink Cable
E6X Amplifier
NV-DI3 Datalink Cable
E6M Amplifier
AUDIO OUTPUT
CONNECT TO NV-E6X
NETWORK
CONNECT TO
NV-EZP
DIGITAL OUTPUT
CONNECT TO
NV-E6X
+12V OUTPUT PULSE
123456
SUM
ODD NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)
EVEN NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)
IR EMITTER OUTPUTS
AUDIO OUTPUT
DIGITAL INPUT
CONNECT TO NV-E6M
CONNECT TO
NV-E6M
AUDIO INPUT
The NV-EKP keypads are the heart of the NUVO
system. You are now ready to install the keypads,
address them for each zone they will be controlling,
adjust preset EQs, and group them as necessary,
using a series of DIP switches located on the back of
the keypad.
The amplifier should be plugged into an AC outlet,
and the Power button on the front panel turned on.
The blue Stand By LED should be lit.
The following section will be devoted to properly setting
the eight DIP switches on each of the systems keypads.
Fig. 7: NV-EKP Keypad back panel
12345678
O
N
VII. Installing the NV-EKP Keypads