Filter
Top Products
R
L
SENSITIVITY
OdBV = 1.0RMS
-12
+6
0
LEFT
+6
-12
RIGHT
0
AUDIO
INPUT
2
INPUT
OUTPUT
CONTROL
VOLTAGE
TRIGGER
3-30 VOLTS
AC OR DC
ON/OFF SWITCH
AUDIO AC/DC
POWER
MODE
CONTROL
SOURCE LINK
SOURCE INPUTS
ZONE 1
ZONE 3
ZONE 2
CONNECT TO
NV-I8X
USE NV-SLC1
CABLE
1 2 3 4 5
6
1 2 3 4 5
6
ZONE 1
ZONE 3
ZONE 2
OUTPUT POWER
OUTPUT POWER
OUTPUT POWER
40W/6OHM X2
40W/6OHM X2
40W/6OHM X2
VARIABLE
OUT PUT
VARIABLE
OUTPUT
VARIABLE
OUTPUT
FIXED
OUTPUT
FIXED
OUTPUT
FIXED
OUTPUT
TIP=L
RING=R
TIP=L
RING=R
TIP=L
RING=R
NV-P2100 Amplifier
Grand Concerto Amplifier
ZONE 6
ZONE TRIGGER OUTPUTS
ZONE 5
1
1
3
5
7
5
2
4
6
8
35
NV-P2100 200-Watt Auxiliary Amplifier (Fig. 55)
The P2100 is specifically designed for use with the NuVo
Systems’ lineouts. It can be used with either the fixed or
variable lineouts on the Grand Concerto amplifier. The
connection is made using either a 1/8 to 1/8 stereo patch
cable or a 1/8 stereo to RCA patch cable.
There are two methods for triggering the P2100 from the
Grand Concerto outputs. One is to set the POWER MODE
switch on the P2100 to AUDIO (extreme left) position and
allow an incoming audio signal from the Grand Concerto
System to turn on the P2100. The second method is to place
the POWER MODE switch in the AC/DC (extreme right)
position. This will turn on the P2100 when the Grand
Concerto is on.
An additional feature of Grand Concerto is Zone-Specific
Triggers that will trigger the P2100 only when that zone is
turned on. Utilizing the voltage trigger requires a mono 1/8
patch cable from either the System ON output on the Grand
Concerto to the P2100 Voltage trigger input, or from the
specific Zone Trigger on the Grand Concerto to the Voltage
Trigger on the P2100, as shown in Fig. 55.
RS232 Interface
The RS232 port allows external two-way communication with
the Grand Concerto System. Home automation systems can
be set up to operate Grand Concerto. The RS232 protocol
document is available for download from the website
Prozone at www.nuvotechnologies.com/prozone.
Fig. 55