Filter
Top Products
CDN-88 Dual CD Player
- The Leader in DJ Technology
©2000 Numark Industries
- 6 -
http://www.numark.com
DESCRIPTION CDN-88REMOTE FEATURES
1
2
3
4
11
12
10
987
6
20
5
13
14
15
16
17
19
18
21
22
23
24
25
1. OPEN/CLOSE- Pressing will open or close the disc tray on the
transport.
2. LCD DISPLAY- Indicates all the functions, as they are
occurring, with the CD.
3. WHEEL- Used for various functions such as cueing, scratching,
pitch bend, searching, and effect control
4. PLAY/STUTTER- To start the music from the initial cue point.
5. PAUSE- To pause the music.
6. CUE- To move the music to the cue point and preview the
selection.
7. SING- To set play mode in single or continuous play.
8. TIME- Controls display indication of time mode.
9. SEARCH- Puts wheel in search mode.
10. <<, >>, +10- Used for selecting tracks.
11. PROGRAM- Used for setting track order and various special
commands.
12. EFFECT SELECT/HOLD- Used to determine desired effect.
13. EFFECT INDICATOR- Shows selected effect.
14. EFFECT ACTIVE- Used to put the wheel in effect mode.
15. KEY- Used for various key control.
16. -,+ - Works as pitch bend and controls key and pitch functions.
17. PITCH- Actives and sets pitch slider range.
18. PITCH SLIDER- Controls the overall speed of the music.
19. LOOP IN- Used to set stutter and loop in points.
20. LOOP OUT- Used to set loop out points and release the loop.
21. RELOOP/STUTTER- Used for repeated play (stutter) from the loop
in point, repeating a previously set, and hot start.
22. MARCHING BAR GRAPH- Tracks the beats and measure position
of music in both units and indicates when they match.
23. BEAT SYNC- Used for various Beatkeeping functions.
24. AUTO START- Used for setting Relay, Fader, and Automatic play
start.
25. INTERLOCK- Links both players for beat alignment.
26. FADER START JACK (not shown)- Located on the rear of the
control unit for remotely starting your CD player from a similarly
equipped mixer.
TRANSPORT FEATURES
27. DISC TRAY- Place your CD in here.
28. OPEN/CLOSE (Disc Tray Open/Close) - Press to load or eject
the disc. NOTE: Tray will not open unless the disc is not in play.
29. POWER BUTTON – To turn the machine on and off.
30. RCA AUDIO JACKS - Connect your CD player to your mixer
from this line level output.
31. VOLTAGE SELECTOR - Set this switch to the voltage for your
location.
32. POWER CORD - Plug your unit into a power outlet.
33. CONTROL CONNECTOR - Plug your control cables for each
unit into here and the back of the remote unit.
27 28 29
30
31 32
33
34
34. DIGITAL OUTPUTS - The output format is type 2, form 1, also
known as S/PDIF (Sony/Phillips Digital Interface Format). In order
to use the digital output you must first activate it through the
“PROGRAM” features. Once activated you can not use variable
pitch slider, the pitch bend buttons, or loop when active. If you wish
to use the digital output of the unit, you must first set the digital out
mode or the output sampling rate will be incorrect.