Filter
Top Products
2 VHF 7000, 7100US, 7100EU Operation Manual
NAVMAN
IMPORTANT:
1. Some features described in this manual are not available on every model.
In particular, DSC functions are NOT available on the 7000.
2. DSC functions will not operate on the 7100US or the 7100EU until your
MMSID has been entered. Refer to section 4.2 for details.
3. The radio channels installed into the Navman VHF radio may vary from
country to country, depending upon the model, and government or
national communications authority regulations.
4. Navman NZ Ltd recommends that you check the radio operating licensing
requirements of your country before using the Navman VHF radio. The
operator is solely responsible for observing proper radio installation and
usage practices.
5. A DSC warning label is supplied with the 7100US. To comply with FCC
regulations, this label must be afxed in a location that is clearly visible
from the operating controls of this radio. Make sure that the chosen
location is clean and dry before applying this label.
It is the owner’s sole responsibility to install and use the instrument in such a manner that will
not cause accidents, personal injury or property damage.
Navman NZ Limited disclaims all liability for any use of this product in a way that may
cause accidents, damage or that may violate the law.
Governing Language: This statement, any instruction manuals, user guides and other
information relating to the product (Documentation) may be translated to, or has been
translated from, another language (Translation). In the event of any conict between any
Translation of Documentation, the English language version of the Documentation will be the
ofcial version of the Documentation.
This manual represents the Navman VHF 7000, 7100US, and &7100EU radios at the time
of printing. Navman NZ Limited reserves the right to make changes to specications without
notice.
Copyright © Navman NZ Limited, New Zealand. All rights reserved. NAVMAN is a registered
trademark of Navman NZ Limited.
FCC Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of FCC Rules. These
limits are designed to provide a reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try and correct the interference by one or more of the following
measures:
• reorient or relocate the receiving antenna.
• increase the separation between the equipment and receiver.
• connect the equipment into an outlet on a circuit different from that to
which the
receiver is connected.
• consult the dealer or an experienced radio/TV technician for help.