Nakamichi Stereo Music System Stereo System User Manual


 
30
Stereo Music System
Troubleshooting
No power.
- Verify that the plug of the power cord is plugged properly into
the AC outlet.
................................................................................................
No sound.
- Verify that all connections are established properly.
- Verify that volume level is set to a suitable position.
- Verify that mute function is disabled.
- Verify that speakers are connected properly.
- The protection circuitry may have been activated. Stop play-
back of the program source and wait a while until the ampli-
fier automatically resets itself.
................................................................................................
Some channels are interchanged.
No sound in some channels.
- Verify that audio equipment connections are established prop-
erly.
- Verify that balance is set correctly.
................................................................................................
Hum is heard.
- Verify that all connections are established properly.
Some apparent malfunctions may be remedied by simple checks as described below. If the problem persists, please contact your
dealer or an authorized Nakamichi service center.
After insertion, a disc is ejected again.
- The disc was inserted upside down. Insert the disc with the
label facing up.
................................................................................................
Disc playback is not possible, sound is unstable, or
skipping occurs.
- If the disc is dirty, clean it.
- If the disc is scratched, use another disc.
- Turn off the CD player and other components, and check all
connections.
- Moisture may have condensed on the pickup lens. Turn the
unit on and let the unit warm up for about 30 minutes to one
hour.
...............................................................................................
Memory play is not possible.
- The contents of the memory may have been lost. Repeat the
memory programming procedure.