Filter
Top Products
9
During manual programming, the selected
function will flash for five seconds or press
the Set button to confirm the selection and
the display will return to the main menu.
The AUTO-SCAN / ASC (IR Sync) Button (2)
has two functions:
•Long press (hold ~2 seconds) for AUTO-
SCAN for finding a clear channel within
the frequency band (with all TXs turned off
at this time). Clockwise running segments
on the LCD display show the scanning
is in progress which normally takes ten
seconds. When it finds an interference-
free channel, it will display and store that
channel for use. Then ASC IR Sync the TX
as described below.
•Short press (hold ~ 1 second) to transfer
the selected frequency information from
the receiver to the transmitter for easy
synchronization prior the transmitter can
be used. When short pressing the ASC
IR Sync button while the main menu is
displayed, the IR LED (4) will light up red
and stay for about five seconds. This
indicates IR transmission is in progress
and IR data is transferring during this
period. A transmitter should be used
at this time to receive data from the
receiver (see IR Sync Programming in
Programming sections of HT-1KU and
BT-1KU transmitter sections). Upon
successful data transferred (usually in
about three seconds) the IR LED stops
and the transmitter’s backlight will light
up and the transmitter will transmit a
radio signal on the same channel as the
receiver. The Signal Strength and Diversity
Indicators on the receiver’s display will
then light up, indicating that the IR link is
completed. If manual channel selection is
preferred, skip this selection.
Note: If you are using multiple transmitters at
the same location, set up the first transmitter
and leave it ON and keep it 3 ft. away from
the receivers. Then start AUTO-SCAN on the
second receiver. This avoids duplicate selection
of the same channel as already selected for the
first receiver. Repeat these procedures for the
remaining receivers to be used with the system.
If you are not satisfied with a channel after
scanning, repeat anytime for locating another free
channel.
Selecting the 8W-1KU Receiver
Volume Level / Group / Channel
This section will also aid in finding desired
channel(s) of operation when setting up
your system(s).
Press the Set Button (6) 3 times to check
the current Volume Levels (12) setting. To
change the Volume Levels, press the
(Up) or (Down) Buttons (7) anytime for
single stepping, or hold the Up/Down button
continuously for faster level selection.
Select 1 of 63 (soft to loud sound) levels
from the Volume menu and advance to exit
Setup Mode by pressing the Set Button
one more time. Selecting 0 should mute the
receiver and no output for the Line Out only.
The XLR out is unaffected.
Choose the 8W-1KU operating frequency
by selecting one of 10 Groups (9) and one
of 100 Channels (10) that are determined to
be desirable open channels. Press the Set
button to enter the Group setup mode and
the Group icon will flash, then press the
Up/Down button once for single stepping
through the groups, or hold continuously
for faster group selection. Select 1 of 10
groups available from the Group menu and
then press the Set button again to Channel
Setup Mode and the Channel icon will flash,
or press the Set button three times to skip
changing the Channel or Volume. Within the
Channel Setup menu, press the Up/Down
button once for single stepping through the
channels, or hold continuously for faster
channel selection. Select 1 of 100 channels
available from the Channel menu or press
the Set button twice to skip Volume Level
setting and exit to main menu. During
manual programming, the selected function