Filter
Top Products
19
Feedback
Avoid acoustic feedback (howling or
screeching) by taking care in selecting PA
volume, transmitter location and speaker
placement.
Please also note the pickup pattern
characteristics of the microphone selected.
Unidirectional mics are more resistant to
feedback. However, they pick up sound
sources best that are directly in front of the
mic. Also mics that are farther from the
sound source require more acoustic gain
and thus are also more prone to feed back
than close-source mics such as handheld.
No or Low Audio
If you are not getting audio through the
system, carefully re-check all setups.
Especially note that the receiver and
transmitter must be set to operate on the
same RF channel. For BT-1KU bodypack
transmitter, also confirm that the Power
Off/Mute/On Switch (38) is not in the Mute
position. The receiver’s Unbalanced Line
Level Out (17) is adjustable so make sure the
Volume (11) is set properly.
RF Interference and Finding Open
Channels
If you encounter slight receiving
interference when the transmitter is
far from the receiver (from other than
an operating TV station on the same
frequency), often it can be overcome by
adjusting the receiver‘s Squelch Control (16)
(see Adjusting the Squelch). If receiving
interference on a selected channel with
the transmitter off, you must reprogram
the receiver and transmitter to a different
channel.
See: Selecting the 8W-1KU Receiver Volume
Level / Group / Channel
Programming the HT-1KU/BT-1KU to the
Selected Channel
To reprogram, you must first find an open
channel. To do this, follow the operating
procedure outlined in Selecting the 8W-1KU
Volume Level / Group / Channel. With the
associated transmitter off, scroll through
the groups/channels to find one that
shows no received signal on the receiver’s
RF Signal Meter (12) (no bars). Also, there
must be no bars either on each of the
three immediately adjacent channels both
above and below the selected channel for
optimum interference-free operation (i.e. in
a field of seven adjacent channel total—
with the channel used in the middle). If
operating multiple 8W-1KU Series systems
simultaneously, repeat this procedure
with every new channel being selected,
with previously tuned systems all on, both
transmitters and receivers.
Please note that wireless frequencies are
shared with other radio services. According
to FCC regulations, wireless microphone
operations are unprotected from
interference from other licensed operations
in the band. If any interference is received
by any Government or non-government
operation, the wireless microphone must
cease operation or change frequencies. The
above statement is valid only for use in the
U.S.A.
Note: More bars in the Received Signal (12) icon
indicate good signal strength in operation with the
transmitter on, but more than 1 bar showing with
the transmitter off also indicates the presence of
likely RF interfering signals at that location. If this
happens, select a different GRP/CH. One bar or
less is ideal for interference-free operation.
Cautions and Troubleshooting