Filter
Top Products
1. Basic Setup and Operation 7
First-Time Power-On
3_
4_
1, Install batteries in the remote control. See page 5.
Aim the emitter (bulb)
end of the remote control
at the TV and press the
POWERkey (_. Wait for the
Welcome screen.
I
If you wish to change the
menu language to EspaSol,
press Y then ENTER.
Press t_ to move to the
energy-mode selections.
Select Home.
Press I_ to highlight EXIT.
Press ENTERto clear the menu.
Welcome Screen Energy Options
• Mitsubishi recommends the Home setting,
which produces a picture suitable for home
viewing and uses less power.
• The Retail setting looks best under the bright
lighting often found in commercial settings. In
this mode, the TV uses more power than when
in the Home setting.
This table compares energy choices offered in the
Welcome screen.
Picture Mode Bright Brilliant
Lamp Energy Standard Bright
Use the Picture > Video menu to change the
Picture Mode.
Use the Setup > Energy menu to change
Lamp Energy.
Setting Up and Using TV inputs
The ANT (Antenna) Input
If using an antenna or direct cable service (no cable
box), connect the incoming coaxial cable to the TV's
ANT input. Refer to page 16.
You must perform a channel scan to enable recep=
tion of digital channels, if you skip this step, the TV
can receive only analog channels. The channel scan
will search for high-definition and standard-definition
channels available in your area. Note: Direct cable
service will not include scrambled or premium chan-
nels.
Memorizing Channels with Channel Scan
1, Power on the TV.
Press MENUand open the Setup > Channel menu.
Start channel memorization from the Setup > Channel
menu.
3, Press V to enter the menu.
4_
Highlight Ant Air if connected to an
over-the-air antenna. Highlight Ant
Cable for service over direct cable
(no cable box). Press ENTERto add a
check.
Select the scan type.
• For first-time setup, highlight All channels.
• To scan for channels not already in memory,
highlight Add only new channels. Press
ENTERto add a check.
& Highlight Scan and press ENTER.
Channel memorization may take up
to 15 minutes to complete.
To stop channel memorization before completion,
press CANCEL.
At any time after Channel Scan,
• Use the Setup > Channel > Edit menu to add or
delete individual channels from memory.
• Repeat the All channels scan if you reposition the
antenna or move the TV to a new geographic area
with a different channel line-up.
For assistance call 1(800} 332-2119