Filter
Top Products
15
AUDIBLE INDICATORS
When the MS7220 scanner is in operation, it provides audible feedback.
These sounds indicate the status of the scanner. Eight settings are
available for the tone of the beep (normal, 6 alternate tones and no tone).
To change the tone, use the Multi-Function Button or refer to the
MetroSelect
®
Programming Guide (MLPN 00-02407 or 00-02561).
One Beep
When the scanner first receives power, the green LED will turn
on, the red LED will flash and the scanner will beep once.
(The red LED will remain on for the duration of the beep.) The
scanner is now ready to scan.
When the scanner successfully reads a bar code, the red LED
will flash and the scanner beeps once (if programmed to do
so). If the scanner does not beep once and the red light does
not flash, then the bar code has not been successfully read.
Razzberry Tone
This is a failure indicator. Refer to failure modes page 15.
Three Beeps - during operation
When placing the scanner in program mode, the red LED will
flash while the scanner simultaneously beeps three times. The
red and green LEDs will continue to flash until the unit exits
program mode. Upon exiting program mode, the scanner will
beep three times and the red LED will stop flashing.
When configured, 3 beeps can also indicate a
communications timeout during normal scanning mode.
When using one-code-programming, the scanner will beep
three times (the current selected tone), followed by a short
pause, a high tone and a low tone. This tells the user that the
single configuration bar code has successfully configured the
scanner.
Three beeps will also occur during a manual adjustment of the
beeper tone. With each short depression of the Multi-Function
Button, the new tone will be heard, followed by a short pause
then two more of the new current tones.
Three Beeps - on power up
This is a failure indicator. Refer to failure modes page 15.