Filter
Top Products
Customising the integrated amplifier
24
In addition to configuring the sources, and programming their
levels, you can configure many other aspects of the operation of
the 551 Integrated Amplifier to suit the way your system is set
up, and the way in which you want to use it.
Note that these settings are configured automatically to
appropriate values when you choose one of the standard Type
settings, and you should not normally need to alter them; see
Choosing standard settings, page 16.
To configure the integrated amplifier
● Turn off the integrated amplifier, using the power switch on
the back panel.
● Turn on the power again while holding down the Display key
on the front panel.
The display will show:
Conf
It will then show the first
configuration option:
5OO
● Press Copy to move between the options.
● Press A or V to change the value of the current option.
Specifying information about your system
The following table shows the options you can configure:
Option Initial Value
Communications mode (500 or 200)
5OO
Controller mode (Auto, Con, or NCon)
Auto
System address (1–8)
SA=1
Product address (1–8)
PA=1
Volume control (Vout or Fout)
Vout
Volume mode (VolM or VolS)
VolM
Menu mode (N, 1, or 2)
≤≥N
200 Series CD player (N or Y)
CD?N