Filter
Top Products
Customising the integrated amplifier
18
Configuring the sources
When the integrated amplifier is set to one of the standard
settings the twelve source selection keys on the remote select
the standard labels and inputs, as shown in the table on
page 17.
If the configuration you want is not catered for by one of the
standard settings, you can configure each source individually.
The 551 Integrated Amplifier provides 12 sources corresponding
to the 12 source selection keys on the remote:
CD, Radio, LP, TV, Tape1, Tape2, CDR, Cable, Text, VCR1,
VCR2, and LD.
For each source you can configure:
❍The label used for it on the front panel display, from 45
alternative labels.
❍The audio input it selects.
❍The comms type and address, to identify other Meridian 500
Series equipment.
The procedure for doing this is as follows.
To configure a source
● Turn off the integrated amplifier, using the power switch on
the back panel.
● Turn on the power again while holding down the Display key
on the front panel.
The display will show:
Conf
● Press Source until the left-hand pair of characters identifies
the source you want to configure.
For example, to configure the CD
source the display initially shows:
CDCD
● Press Copy (front panel), or
>>
>>
> and
<<
<<
< (remote), to step
between options.
The right-hand pair of characters shows the current value of the
option.
The options are summarised in the table shown opposite.