Filter
Top Products
E-10
INSERTION AND REMOVAL OF CASSETTE
– Press Stop / Eject Key to open the cassette door.
– Put your cassette tape down the holder properly, with the exposed section Downward and the playback
side facing you.
– Close the cassette door securely before starting.
– When finished press Stop / Eject Key to open the cassette door and retrieve your cassette tape.
PLAYBACK
– You can choose either TAPE A / 1 or TAPE B / 2 for playback.
– Press the TAPE Button.
– Put in your cassette tape.
– Press Play Key to activate playback.
– Adjust the Volume Controls to the desired level.
– Use Pause Key whenever you want to stop playback temporarily.
– Press Stop / Eject Key when finished.
CONTINUOUS PLAYBACK (ONLY FROM A / 1 TO B / 2 DECK)
– Press the TAPE Button.
– Put in your Cassette Tapes.
– Press Play Key of Deck A / 1.
– Press Pause Key and Play Key of Deck B / 2.
– Deck A / 1 will activate while Deck B / 2 is at Rest.
– Adjust Volume Control to the desired level.
– When Tape A / 1 reaches its end and stops. Tape B / 2 starts playing automatically.
– When Tape B / 2 runs to its end. It will automatically stop.
RECORDING
A. RECORDING FROM RADIO
– Press the Tuner button.
– Tune in your station and put in your cassette tape.
– Press Record Key and the Play Key of deck at the same time to start recording.
– Press STOP / EJECT Key when finished.
Note: If beat noise is present when recording. Adjust the position of the Beat Cut Switch on rear panel
for AM only.
B. RECORDING FROM CD
– Press the CD Button.
– Insert a cassette suitable for recording, press pause key then press record key. Recording function will
be on stand by.
– Activate the CD player, and then press (to release) Pause Key to start recording.
– To stop recording, first press STOP Button on CD player – then press the STOP / EJECT Key on tape
deck.
SYNCHRONIZE DUBBING (USING DECK A / 1 & DECK B / 2)
Set in tape mode
– Insert a pre-recorded cassette with full reel on the left into Deck A / 1.
– Insert a blank cassette Tape with full reel on the left into Deck B / 2.
Normal speed dubbing
– Press the Tape Function Selector, set the dubbing mode selector to “NORMAL” position.
– Press Play key of Tape A / 1 and Record Key together with the Play Key of Tape B / 2 at the some
time then both Tapes start dubbing synchronously.
– Adjust the Volume Controls to the desired output level and also for the monitoring purpose.
– To Stop Dubbing, press both Stop / Eject Keys.
High speed dubbing
– Following the steps of normal speed dubbing procedure, but set the dubbing mode selector to “HIGH
SPEED DUBBING” position.
Memorex.p65 11/8/01, 11:11 AM10