Filter
Top Products
7
OPERATING INSTRUCTIONS (CONTINUED)
MUTE
To temporarily mute the sound, press the MUTE button on the
remote control; the Mute indicator will appear in the display and the
sound will be muted. Press the MUTE button again to restore the
sound and the Mute indicator will disappear from the display.
1
Press the POWER ON/STANDBY
button to turn the unit on; the
STANDBY indicator will go out.
1
If listening to FM, slide the FM
STEREO/MONO switch on the
rear of the unit to the desired
position. Noise present in FM
stereo broadcasts can be reduced
by listening in Mono.
4
Press the STOP/BAND (■) button
to select AM or FM.
NOTE: If you select the FM band,
be sure to extend the FM Antenna
Wire.
3
Press the FUNCTION button until
“TUNER” appears in the display.
2
Press the TUNING/SKIP/Search
❶ or ❷ button to select a
station (see Tuning note below).
NOTE: If the FM STEREO band is
selected and you have tuned to an FM
Stereo station, the FM Stereo
indicator will light in the display.
1
2
5
Adjust the PRESET EQ button ❶
and MASTER VOLUME control ❷
as desired.
2
1
6
Hints for Better Reception
FM - Make sure that the FM Antenna Wire is extended to its full length. You may have to vary the direction
of the antenna to find the strongest signal for each FM station.
AM - The AM ferrite bar antenna is located inside the unit. It may be necessary to turn the unit slightly so
that the internal antenna is pointing in the direction of the AM transmitter. You may have to experiment to
find the position that provides the strongest reception for each of your favorite AM stations.
LISTENING TO THE RADIO
TUNING:
MANUAL TUNING: Repeatedly press the TUNING/SKIP/Search or button to manually advance the
frequency in the display up or down until the desired frequency appears.
AUTOMATIC TUNING: Press and hold the TUNING/SKIP/Search or button until the frequency in
the display starts to scan, and then release the button; the tuner will search and then stop on the next strong
station it finds. Repeat this procedure until the desired frequency appears in the display.
MX4111.O/M.QXD 7/11/02 4:06 PM Page 7