Filter
Top Products
15
Power On and Off
Press the POWER switch to ON, the Red LED above the
STANDBY/ON Push-button lights to indicate the MA2275
is in Standby Mode. To
Switch On the MA2275
press the STANDBY/
ON Push-button on the
Front Panel or the
POWER Push-button on
the Remote Control.
The title TUBE WARMUP will illuminate on the Front
Panel (located to the right of the STANDBY/ON Push-
button) with the Audio Outputs muted until the tubes reach
operating temperature. Refer to figures 9 and 10.
Notes: 1. For normal operation,
switch the MA2275 On
and Off with the
Standby/On Push-
button. If the Tube
Integrated Amplifier is
not going to be used for
an extended period of
time, turn Off all AC
Power with the Power
Switch on the Front
Panel.
2. The amount of time
required for Tube
Warmup is dependant
upon the temperature of
the Tubes inside the
MA2275 when the
STANDBY/ON Push-
button is depressed.
3. If there is an
interruption of AC
Power to the MA2275
while it is On, the
internal circuitry will
sense this condition
and will automatically
switch the MA2275
back On when AC
Power is restored.
Input Source Selection
Select the desired Source with
the INPUT Selector Control or
the Source Push-button on the
Remote Control.
How to Operate the MA2275
How to Operate the MA2275
Figure 9
Figure 12
Figure 11
Bass and Treble Controls
Adjust the BASS and TREBLE controls to suit your listen-
ing preferences. The Bass or Treble intensity can be in-
creased with clockwise rotation and decreased with coun-
terclockwise rotation.
Meter Mode Selection
Rotate the Meter Mode Switch to select the meter opera-
tion mode you desire. Refer to figure 11 and 12.
Lights Off - Meter lights are turned off and the meter will
continue to indicate
the power output.
Watts- The meters respond to
all the musical infor-
mation being pro-
duced by the ampli-
fier. They indicate to
an accuracy of at
least 95% of the
power output with
only a single cycle of a 2000Hz tone burst.
Hold - The meter pointer is locked to the highest
power peak in a sequence of peaks. It is elec-
tronically held to this power level until a higher
power peak passes through the amplifier. The
meter pointer will then rise to the newer
higher indication. If no further power peaks
are reached, the meter pointer will very slowly
return to its rest position or lower power level.
The decay rate is approximately 6dB per
minute.
Balance Control
Adjust the BALANCE Control as needed to achieve ap-
proximately equal listening volume levels in each Loud-
speaker. Rotate the BALANCE Control clockwise to em-
phasize the Right Channel by reducing the volume level of
the Left Channel. Rotate the BALANCE Control counter-
clockwise to de-emphasize the Right Channel until equal
Balance of both Channels is achieved.
Note:For an explanation of the Remote Control Push-button
functions, refer to pages 18 and 19.
Figure 10