Filter
Top Products
20
Display Brightness
The MCD201 Front Panel Information Display has three
brightness settings. To change from the default setting
(brightest of the three) perform the following:
1. Press and hold the STOP Push-button and rotate
the TRACK Control counterclockwise, then release
the control for the middle brightness setting. Refer to
figure 6 on page 16.
2. With the STOP Push-button still pressed in, rotate
the TRACK Control counterclockwise again for the
dimmest setting.
3. In a similar manner, increase the brightness by pressing
and holding in the STOP Push-button and rotating
the TRACK Control clockwise, then release the control
for the middle brightness setting. Repeat for the bright-
est setting.
Note: The Display Brightness will return to the default
setting the next time the MCD201 is switched On.
Reset of Microprocessors
In the unlikely event the controls of the MCD201 stop
functioning, the microprocessors can be reset by perform-
ing the following:
1. Press and hold in the STANDBY/ON Push-button for
approximately five seconds. Refer to figure 6 on page
16.
2. When the STANDBY/ON LED is no longer illuminat-
ed, release the STANDBY/ON Push-button.
3. When the STANDBY/ON LED is illuminated press the
STANDBY/ON Push-button, the MCD201 will resume
normal operation.
Note: This can be performed with the MCD201 On or in
the Standby Mode.
Operation in a McIntosh System
The MCD201 basic transport functions may also be con-
trolled by using the Remote Control that comes with a Mc-
Intosh Control Center or Preamplifier. McIntosh Keypads
can also be used to remotely control the basic transport
functions of the MCD201. The labeling of Push-buttons on
some McIntosh Remote Controls and Keypads are differ-
ent from the supplied MCD201 Remote Control. Refer to
the listing below and figures 26 and 27:
MCD201 Remote Control McIntosh Remote Control/
Push-button Keypad Push-button
Pause E
SACD/CD Review
Rev Seek Down
FF Seek Up
Level Up AM
Level Down FM
How to Operate the MCD201, con’t
How to Operate the MCD201, con’t
Figure 26
Figure 27