Filter
Top Products
18
Mute
Press the MUTE Push-button to mute the audio at both the
Fixed and Variable Output Connections on the Rear Panel.
Refer to figure 6. The LED above the MUTE Push-button
will illuminate. Pressing the MUTE Push-button a second
time restores the audio at the output connections and the
LED will no longer be illuminated.
Note: The Headphone Jack is not affected by the Mute
Function.
Direct Track Selection
The MCD201 Front Panel Display indicates the Disc Track
currently playing. Use the Remote Control NUMERIC
Push-button(s) to enter the desired Track Number. Refer
to pages 14 and 15 for additional information using the
Remote Control.
Repeat
This allows repeating a Track or Disc on a continuous
basis. Refer to figures 6 and 12.
1. Start playing the disc or the part of the disc desired to
have repeated.
2. Press the RPT (Repeat) Push-button once to activate the
Track Repeat (1); press the RPT Push-button twice to
activate the Disc Repeat (All). Refer to figures 14 and
15.
3. To cancel the previously selected Repeat Mode, press
the RPT (Repeat) Push-button until the word “REPEAT
1 ” or the word “REPEAT ALL” in the Front Panel
Information Display is extinguished.
A-B Repeat
This feature allows continuous repeating of a specific disc
segment. Refer to figures 12, 16 and 17.
1. Start playing the part of the disc you desire to have
repeated.
2. Press the A-B Push-button once to enter the A (starting
point) and press the same push-button a second time to
enter the B (ending point).
3. To cancel A-B REPEAT function press the A-B Push-
button once again. The word “REPEAT A-B” in the
Front Panel Information Display will extinguished.
Note: The A-B Repeat Mode works within the track
playing. Fast Forward and Reverse functions are
disabled during the A-B Repeat Mode.
Random Playback
This feature allows for listening to Tracks of a Disc in a
Random Order. Refer to figures 12 and 18.
Note: The MCD201 must be in STOP Mode with the Disc
Loaded and the Table of Contents read before the
Random Playback Mode Feature can be activated.
1. With the MCD201 in the STOP Mode press the Ran-
dom Push-button. The word RANDOM should now be
indicated in the Information Display.
2. Press the PLAY Push-button to start Random
Playback. After all the tracks have been played the
MCD201 will stop.
Notes: 1. To provide continuous playback of the disc,
press the RPT Push-button twice to activate the
Disc Repeat (All) after the Random Playback
Mode has started. If Repeat (1) is selected, Ran-
dom Playback Mode is canceled.
2. The BACK TRACK function is not active during
the Random Playback Mode.
3. To cancel the Random Playback Mode, press the
STOP Push-button, then press the Random Push-
button.
Program Playback
This feature allows for the playback of programmed Tracks
of a Disc in the desired order. In the example below, a Disc
is programmed to play Track 6 followed by Track 4 and
then Track 2.
Notes: 1. The MCD201 must be in STOP Mode with the Disc
TOC (Table of Contents) read before the Program
How to Operate the MCD201, con’t
Figure 14
Figure 16
Figure 15
Figure 17
Figure 18