Filter
Top Products
7
Caution: The Loudspeaker Negative Connections are above
chassis ground. Do not combine any connections to-
gether, ground them or connect with another MC1.2KW.
Rear Panel Connections and Switch
Connect the MC1.2KW
power cord to a live AC
outlet. Refer to the rear
panel to determine the
correct voltage
Circuit Breaker,
press to reset if
the amplifier will
not power up
POWER CONTROL IN
receives turn On/Off sig
-
nal from a McIntosh com-
ponent and the POWER
CONTROL OUT sends a
turn On/Off signal to the
next McIntosh Compo-
nent
UNBALANCED INPUT
for an audio cable from a
Preamplifier or A/V Con-
trol Center audio output
INPUT MODE switch
selects between balanced
or unbalanced input
BALANCED INPUT
for an audio cable
from a Preamplifier
or A/V Control Cen-
ter audio output
BALANCED INPUT
1
/ OUT-
PUT for an audio cable from a
Preamplifier
output or to connect
an audio cable onto the next
Power Amplifier input
1
This Balanced connector may be used as an Input ONLY
when connected to a McIntosh C1000 Preamplifier. For
all other connections use only as an Output.
OUTPUT Connections
for 2 ohm Loudspeaker
OUTPUT Connections
for 4 ohm Loudspeaker
OUTPUT Connections
for 8 ohm Loudspeaker