Filter
Top Products
6 Assembly
4 After the second module is in position atop the primary
module, place a level on it as shown. Level the module
front to back by inserting a small allen wrench (or other
suitable instrument) through the hole in the cones on
the base of the module (detail), and rotating the cone
up or down to achieve level.
5 Level the module left to right with the level in position
as shown. Adjust the cone feet for height.
6 Once the secondary module is level, install the stainless
steel Martin-Logan logo plates. You have a choice of
using either a blue or red backing behind the logo—
the vinyl insert is two-sided. Peel the protective plastic
from the insert and position the insert between the
logo plate and line up with the mounting holes on the
top and bottom of the sub modules as shown. Insert
the
3
/8”-16 x 1” button head cap screws—do not
tighten until all 4 screws are started, and then tighten
in a cross-pattern so that all screws tighten down
together. Use a
7
/32” allen wrench.
Figure 5
Figure 6
Figure 7