Filter
Top Products
DescriptionCommandDescriptionCommand
The Nº326S sends infrared signals at 40kHz, the most
common carrier frequency used in learning remote controls.
However, if the learning remote control seems unable to
learn IR commands:
• Eliminate obstructions between the learning remote
control and the left side of the front panel display.
• Adjust the distance between the learning remote control
and the left side of the front panel display.
• Make sure the learning remote control and the left
side of the front panel display are not exposed to
strong sunlight, halogen light, or fluorescent light.
This can cause IR reception to become unreliable.
• Replace the learning remote control batteries.
• If problems persist, contact an authorized Mark
Levinson dealer.
The table below indicates all available IR commands. For
toggle commands, the Nº326S provides one IR command
for the toggle command as well as separate IR commands
for the positive and negative forms of the toggle command.
For instance, the MUTE KEY IR command teaches the
learning remote control to perform mute button commands,
while the GO MUTE IR command teaches the learning
remote control to activate mute and the GO UNMUTE IR
command teaches the learning remote control to deactivate
mute.
VOLUME UP
VOLUME DOWN
SELECT NEXT
SELECT PREV
INTENSITY
MUTE KEY
MONO KEY
POLARITY KEY
STANDBY KEY
ENTER KEY
SETUP KEY
BALANCE KEY
EXIT STANDBY
GO STANDBY
GO INPUT 1
GO INPUT 2
GO INPUT 3
GO INPUT 4
GO INPUT 5
GO INPUT 6
GO INPUT 7
GO MUTE
GO UNMUTE
GO BALANCE
EXIT BALANCE
DISPLAY OFF
DISPLAY DIM
DISPLAY HALF
DISPLAY FULL
3-9
Nº326S Preamplifier Setup Menu
No326S Setup
Set Inputs
Teach IR
Mute = -20.0
MaxVol= 80.0
Trig.= 12v,L
Sw 1.00 B.18
Teach IR
enter
VOLUME UP
EXIT STANDBYPerforms volume + button commands.
Takes the Nº326S out of standby.
VOLUME DOWN
Performs volume – button commands.
SELECT NEXT
GO STANDBY
Performs select + button commands.
Places the Nº326S into standby.
SELECT PREV
GO INPUT 1-7
Performs select – button commands.
Selects the input assigned for the
corresponding stereo input connector
(1-7).
INTENSITY KEY
GO MUTEPerforms display button commands. Activates mute.
MUTE KEY
GO UNMUTEPerforms mute button commands. Deactivates mute.
MONO KEY
GO BALANCEPerforms mono button commands. Opens the balance control.
POLARITY KEY
EXIT BALANCEPerforms polarity button commands. Closes the balance control
STANDBY KEY
DISPLAY OFFPerforms standby button commands. Sets display intensity to 0%.
ENTER KEY
DISPLAY DIMPerforms enter button commands. Sets display intensity to 25%.
SETUP KEY
DISPLAY HALFPerforms setup button commands. Sets display intensity to 50%.
BALANCE KEY
DISPLAY FULLPerforms balance button commands. Sets display intensity to 100%.