Filter
Top Products
21
Nº532 Power Amplifier
The figure below illustrates a typical ML Net setup:
Discovering Slaves
Before the master device can control any slave device, the slave
devices must be “discovered” and assigned to the master device.
Refer to the Owner’s Manual of the designated master device for
further information about discovering and assigning slave devices.
Status Reporting
The Nº532 slave(s) can report the following status information to
the master device:
• Temperature – the current operating temperature of the
amplifier(s).
• Session Time – the amount of time that the amplifier(s) has
been powered on.
• Total On Time – the total amount of hours that the Nº532
amplifier(s) has been powered on since its manufacture.
If a slave device is inactive, unassigned, or assigned to a different
master, then status information is not available.
Fault Reporting
The Nº532 slave(s) also reports fault information to the master
device. If a slave device is inactive, unassigned, or assigned to a
different master, then error reporting is not available. For more
information about possible fault conditions, refer to the
“Troubleshooting” section of the manual.