Filter
Top Products
ENGLISH
6
SETUP
PLC SETTING
RECALIBRATION
If audio is lost when the ZC4001 and ZR6001 are
connected over a PLC connection, recalibrate the
signal to the best carrier frequency.
The ZR6001 is set first.
<ZR6001>
Using the OSD menu system, set “MULTI PLC
SERVER” to “ON”.
ZR6001 ON SCREEN DISPLAY MENU SYSTEM
1.
Select “9. MULTI PLC” in the SETUP MAIN
MENU with the
or cursor buttons, and
press the ENTER button.
2.
Select “MULTI PLC SERVER” with the or
cursor buttons. And select “ON” with the or
cursor buttons.
For details, see page 24 in the ZR6001 User’s
Guide.
<ZC4001>
1.
Press and hold the ENTER button for 5 sec. or
more.
2.
Press the ENTER button.
3.
The below message appears when
recalibration is complete.
SET GROUP ID
To set a Group ID, connect the AC power cables of
the ZC4001 and ZR6001 to wall power outlets as
close to each other as possible.
Set the Group ID simultaneously for the ZC4001
and ZR6001.
<ZR6001>
Using the OSD menu system, set “GP-ID
SETTING” to “START”.
1.
Select “9. MULTI PLC” in the SETUP MAIN
MENU with the
or cursor buttons, and
press the ENTER button.
2.
Select “GP-ID SETTING” with the or
cursor buttons.
<ZC4001>
1.
Press and hold the ENTER button for 5 sec. or
more.
2.
Press the button once.
1. 2.
1
.
1. 3. 2.
1
.
3.
Simultaneously press the ENTER buttons of
the ZR6001 and ZC4001.
<ZR6001>
GP-ID SETTING :
<ZC4001>
The below message appears when the Group ID
has been successfully set.
<ZC4001>
<ZR6001>
GP-ID SETTING : SUCCEED
The below message appears if the units fail to set
the Group ID.
<ZC4001>
<ZR6001>
GP-ID SETTING : MISSING
Notes:
One possible reason the Group ID cannot be set is
power line noise. In that case, unplug the power
cable of the device that is generating noise, then
plug it back in and try setting the Group ID again.
9MULTI PLC
MULT I
CONNECT I ON MODE :
AUTO
H IGH AUDI O QUAL I TY
HIGH RELIABILITY
GP
ID SETTING:START
MA I N EX I T
PLC SERVER:ON
9MULTI PLC
MULT I
CONNECT I ON MODE :
AUTO
H IGH AUDI O QUAL I TY
HIGH RELIABILITY
GP
ID SETTING:START
MA I N EX I T
PLC SERVER:ON
06.3.30, 9:10 AMPage 6