Filter
Top Products
8
ENGLISH
CONNECTIONS
WIRING SPEAKER CABLE
• Peel off the coating of speaker cable as shown below.
Approx. 1 cm
Cut the coating
of cable.
Peel off the edge
of cable.
Twist conductors.
• Wiring with speaker cable.
Turn counter-
clockwise to loosen.
Insert conductor
of cable.
Turn clockwise to
tighten.
• Wiring with “Y” style terminal
Turn counter-
clockwise to loosen.
Insert conductor. Turn clockwise to
tighten.
Your speaker system needs to meet the following requirements.
If speakers that do not meet the following requirements are
used, the amplifier protective circuit may trip, and sounds will
not playback correctly. In certain cases, damage may also be
caused to the amplifier and speaker system.
• If using 1 set of speakers, total speaker impedance must be
4Ω or more.
• If using 2 sets of speakers, total speaker impedance must
be 8Ω or more.
• When using the speaker system in BTL mode, use a speaker
system that has an impedance of 8Ω or higher.
Notes:
• To prevent damage to circuitry, do not let the bare speaker
wires touch each other and do not let them touch any metal
part of this unit.
• Do not touch the speaker terminals when the power is on.
It may cause you to receive an electric shocks.
• Do not connect more than one speaker cable to one
speaker terminal. Doing so may damage this unit.
• Be sure to connect the positive and negative cables for
the speaker properly. If they are miss-connected, the
signal phase will be reversed and the signal quality will
be corrupted.