Filter
Top Products
1.
Press theTRIM button once to access the LEVELtrimming
mode.
Note:
Trimming is performed from the remote controller.
There are three trimming modes.
• LEVEL trimming that adjusts the volume level
on
left and
right channels
• BASS trimming that adjusts the bass on left and right
channels
• TREBLE trimming that adjusts the treble
on
left and right
channels
I
[~_H_O_W_T_O_U_S_E_A_N_D_S_E_T_FE_A_:r_U_R_E_S
~]
II
(TRIMMING • How
to
Trim Volume Level
The volume level of the left and right channels can be trimmed
in
0.5dB steps across a 0.0 -
9.OdB
range. When the unit
is shipped from the factory, the volume level is set to
O.OdB
(maximum).
TRIM
EXIT
•
T
~
~
ENTER
:This button starts trimming. When multiple
SC-11
S1s
are connected, this button selects the amplifier with
which to perform trimming.
In
such case, trimming
is performed
in
the order of the lowest to highest
10
number.
This button ends trimming.
This button increases the trimming level.
This button decreases the trimming level.
This button selects the R channel for trimming.
This button selects the L channel for trimming.
This button selects the trim mode (LEVEL, BASS
orTREBLE).
2. The flashing "0.0" on the left indicates that trimming is
activated for the leftchannel volume level. Press
the.
and
T buttons to set the volume level of the left channel.
L LEi,}EL
F.:
3. Press the
~
button to set the right channel volume level.
When the right side "0.0" starts flashing, trimming is
activated for the rightchannel volume level. Press
the.
and
T buttons to set the volume level of the right channel.
L LE!,}EL
F:
.
....
6)21
...
6.1]
""'"
cco
..
©
4.
To
trim the volume level of the
102
(slave) unit, press the
TRIM button again and set the volume level as in steps
1-3.
After that, pressing the TRIM button again allows you
to trim the volume level for the
"10
3" unit and so forth.
5. When finished with volume level trimming, press the EXIT
button.
o
c:::::::J
.~.DOOI
$CAN
Ill:l'f.Ol
I I
~
.......
_ lIE....
I I
Dlapanlz
22