Filter
Top Products
12
ENGLISH
OPERATION
* In this instruction manual, some operations can only be performed with the remote control. For operations that can be
performed with buttons both on the main unit and on the remote control, the button names are shown in the mark.
And for operations that can only be performed with buttons on the remote control, the button names are shown in the
mark.
CONNECTING THE POWER SUPPLY
1 Plug the power cable into AC IN jack on the back panel.
2 Turn on the power switch of the audio unit (amplifier, etc.)
that is connected with this unit. Set the selector on the
connected unit to this unit.
3 Plug the power cable into an AC outlet.
NORMAL PLAYBACK
7 Super Audio CD player playback
qw, e r
DISPLAY OFF
q Press POWER switch to turn on.
LCD
The display cycles from TOC Reading → No Disc (when
no disc is loaded) → Super Audio CD (when the start sound
mode setting is Super Audio CD).
w Press the
OPEN/CLOSE
button
The disc tray comes out. Place the disc with label side up
on the tray.
To play a single (8cm) CD, place the disc with the
indentation at the center of the tray.
e Press
OPEN/CLOSE
button.
r Press
PLAY
button.
Disc type is automatically detected and playback is started.
Track number and track elapsed time(minute, second)
appear on the display.
* For Super Audio CD/CD hybrid-layer discs (See page 3),
the layer that is set in the start sound mode (See page
14) is played. To change the layer, use the
SOUND MODE
button. (See page 14)
(Exp.:Track 6, Elapsed time 2 min 8 sec)
Playback automatically stops at the end of the final track.
Number of current track
Minutes Seconds
Remaining track numbers
AC IN
06.8.29, 1:52 PMPage 12