Filter
Top Products
12
NAMES AND FUNCTIONS BASIC CONNECTIONS BASIC OPERATION
ADVANCED CONNECTIONS
APPLICATION OPERATION TROUBLESHOOTING OTHERS
BASIC OPERATION
ENGLISH
BASIC OPERATION
NORMAL PLAYBACK
7
Super Audio CD player playback
OPEN/
CLOSE
PLAY
STOP
PAUSE
1. 4.2. 3.
1.
Press POWER switch to turn on.
Display
The display cycles from “Power On” →“TOC Reading” →
“No Disc” (when no disc is loaded).
2.
Press the 0 button.
The disc tray comes out. Place the disc with label side up
on the tray.
To play a single (8cm) CD, place the disc with the
indentation at the center of the tray.
3.
Press 0 button.
Caution:
Do not close the disc tray by pressing it in with your hand, as
this will damage it.
4.
Press 2 button.
Disc type is automatically detected and playback is
started. Track number and track elapsed time (minute,
second) appear on the display.
• For Super Audio CD/CD hybrid-layer discs (see page
4), the layer that is set in the start sound mode (see
page 20) is played. To change the layer, use the SOUND
MODE button (see page 20).
(Exp.:Track 6, Elapsed time 2 min 8 sec)
Number of current track Minutes Seconds
Playback automatically stops at the end of the final track.
¶
To stop playback
Press 7 button.
¶
To eject disc
Press 0 button to open the disc tray and take the disc off.
Press the button again to close the tray.
Disc tray must be closed when the unit is not be used.
¶
To pause playback
Press 8 button.
“PAUSE” indicator will light and playback is paused at the point
that the button is pressed. To restart playback, press 8 button
again or press 2 button.