Filter
Top Products
ENGLISH
3
Notes about the discs
* Handle the discs carefully so as not to scratch their
surfaces.
* Keep the surfaces of the discs clean at all times.
When cleaning the surfaces of discs, always be sure to
use the special cleaner and wipe the surfaces in the
directions shown in the figure below.
* Do not attach pieces of paper or stickers to the label
surfaces of the discs.
When a disc has a piece of plastic tape or rental CD label
with paste protruding from the edge or when a disc still
bears traces of sticky tape or adhesive labels, do not
attempt to play it. If such a disc is played on the CD player,
you may find that you cannot remove it or that some other
kind of malfunctioning may occur.
* Do not use discs which come in special shapes.
Do not attempt to play heart-shaped or octagonal discs or
discs with any other special shapes. You may find that
you cannot remove them or that some other kind of
malfunctioning may occur in the player.
* Use discs which satisfy the CD standards such as those
with the “CD logo” or “
” mark on their disc label
surfaces.
No guarantees are made for playback if discs which do
not satisfy the appropriate CD standards are used.
Similarly, no guarantees are made for their sound quality
even if it is possible to play such discs.
* To protect your discs from damage, avoid placing them
in the following locations.
• Where they will be exposed to direct sunlight or where
they will be close to a heater or other heat-radiating
appliance
• Where the humidity level is high or it is very dusty
• Near a window or other such location where they may be
exposed to rain
* Get into the habit of putting the discs back in their cases
after use.
1. BEFORE USING
Inappropriate places for installation
To keep your player in perfect working order for the longest
possible time, avoid installing the player in the following
locations.
• Wherever it will be exposed to direct sunlight
• Wherever it will be close to a heater or other heat-radiating
appliance
• Wherever the humidity is high or ventilation is poor
• Wherever it is very dusty
• Wherever it will be subject to vibration
• On top of a rickety stand or in an unstable location which
is tilted at an angle
• On top of an amplifier or other component which dissipates
a great deal of heat
• In an audio rack with little space at the top and bottom or
other location where the heat dissipation will be obstructed
To ensure proper heat dissipation, install the player while
leaving clearances between the player and wall or other
components, as shown in the figure below.
PLAY/PAUSE
+
OPEN/CLOSE
CUESTOP
EASY JOG
-
PHONESLEVELQUICK REPLAY
POWER ON/OFF
CD PLAYER PMD325
1
23456789
0
TIMER
DISC
TEXT
1234567891011121314151617181920
TTL
TRK INDX
TTL
TIME
MP3
RNDM
PROG A
—
B
RPT
1
S.PLAY
END
WARNING
ALBUM
— +
• Wipe the surface radially
from the center.
• Do not wipe the surface in
the circumferential direction.
10 cm or more
10 cm or more
2 cm or more
Installation precautions
In order to ensure that the unit will operate correctly, install
and operate it within +/-10 degrees from the horizontal plane.
If the unit tilts too far in one direction, its disc may be pinched
or it may not be possible to open and close the disc holder
properly.
When the unit is to be installed in a 19-inch rack for use, secure
it firmly in four places.
Refer to page 45 for the outline drawing.
10°10°
10°
10°
P
L
A
Y
/
P
A
U
S
E
+
O
P
E
N
/
C
L
O
S
E
C
U
E
S
T
O
P
E
A
S
Y
J
O
G
-
P
H
O
N
E
S
L
E
V
E
L
Q
U
IC
K
R
E
P
L
A
Y
P
O
W
E
R
O
N
/O
F
F
C
D P
L
A
Y
ER
P
MD
32
5
1
2
3
45
6
7
89
0
T
IME
R
DISC
T
E
X
T
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1617
18
1920
T
T
L
TRK
INDX
T
T
L
TIM
E
MP
3
R
N
D
M
P
R
O
G
A
—
B
R
P
T
1
S
.PLAY
E
N
D
W
A
R
N
IN
G
A
L
B
U
M
—
+
5 cm or more