Filter
Top Products
21
ENGLISH
21
If a problem occurs, fi rst check the following:
1. Are the connections correct?
2. Is the unit being operated as described in the owner’s manual?
If this unit does not operate properly, check the items listed in the table below. If the problem persist there
may be a malfunction.
In this case, disconnect the power immediately and contact the retail outlet.
Symptom Cause Countermeasure Page
The disc does not
rotate.
• The power cable is not plugged
in.
• Plug the power cable into a
household power outlet.
7
• Power of this unit is not turned
on.
• Turn on power to the unit.
8
• The disc is not set correctly. • Set the disc correctly. 3
• The disc is placed upside-down.
(The label of the disc is facing
down.)
• Set the disc correctly.
3
• The disc is dirty. • Clean the recording surface of the
disc.
4
• The disc is scratched. • A disc with many scratches may
not be playable.
–
• The disc is warped. • A warped disc may not be
playable.
–
The disc rotates
but there is no
sound output.
• The amplifi er or speakers are
not connected correctly.
• Connect the cables correctly.
(Refer to User Guide supplied
with the amplifi er.)
–
• Power to the amplifi er is not
turned on.
• Turn on power to the amplifi er.
(Refer to User Guide supplied
with the amplifi er.)
–
• The function or input source
selector switch of the amplifi er
is not set to “CD” or “AUX”
(amplifi er terminal to which this
unit is connected).
• Set the function or input source
selector switch of the amplifi er
to “CD” or “AUX” (amplifi er
terminal to which this unit is
connected). (Refer to User Guide
supplied with the amplifi er.)
–
• The amplifi er volume is set to
minimum.
• Adjust the amplifi er volume.
(Refer to User Guide supplied
with the amplifi er.)
–
The display does
not light during
playback.
• The Audio EX function
([SOUND MODE]) is set to
“Audio EX2”.
• Set the Audio EX function
([SOUND MODE]) to “Audio EX
OFF” or “Audio EX1”.
14
Symptom Cause Countermeasure Page
The disc stops
rotating.
• The disc is dirty. • Clean the recording surface of the
disc.
4
• The disc is scratched. • A disc with many scratches may
not be playable.
–
• The disc is warped. • A warped disc may not be
playable.
–
• The disc being played is not a
music CD. Or MP3/WMA fi les
are not recorded on the disc.
• A CD-ROM meant for a personal
computer cannot be played. 17
The remote
control does not
operate.
• The distance between the unit
and remote control is too great.
• Use the remote control closer to
the unit, within operational range.
4
• There is some object between
the unit and remote control.
• Remove the object.
4
• The batteries in the remote
control are expended.
• Replace all batteries with new
batteries.
4
• The remote sensor of the unit is
exposed to strong light.
• Avoid exposing the remote
sensor to strong light.
4
• The EXTERNAL/INTERNAL
switch of the unit is set to
“EXTERNAL”.
• To use this unit without an
amplifi er, set the remote control
switch to “INTERNAL”.
12
CD-R/CD-RW disc
cannot be played.
• The disc is placed upside-down.
(The label of the disc is facing
down.)
• Set the disc correctly.
3
• The recorded data is not written
in an audio (CD-DA) format. Or
the MP3/WMA fi les are not
recorded correctly.
• Record data that is applicable to
this unit.
17
Pitch control
operation cannot
be performed.
• The Audio EX function ([SOUND
MODE]) is not set to “Audio EX
OFF”.
• Set the Audio EX function
([SOUND MODE]) to “Audio EX
OFF”.
14
Digital audio
signals are not
output.
• The “Digital Out” setting is set
to “Off”.
• Set the “Digital Out” setting to
“On”.
16
• The Audio EX function ([SOUND
MODE]) is set to “Audio EX2”.
• Set the Audio EX function
([SOUND MODE]) to “Audio
EX1”.
14
• The Audio EX function
([SOUND MODE]) is set to
“Audio EX OFF” and pitch
control is used.
• Set the pitch control “Pitch: 0”.
• Or, set the Audio EX function
([SOUND MODE]) to “Audio
EX1”.
14
Troubleshooting