Filter
Top Products
13
NAMES AND
FUNCTIONS
BASIC
CONNECTIONS
BASIC
OPERATIONS
ADVANCED
CONNECTIONS
ADVANCED
OPERATIONS
TROUBLESHOOTING
OTHERS
TROUBLESHOOTING
ENGLISH
TROUBLESHOOTING
If you have any problem using this product, please be sure to check the items in the following table.
If you trouble cannot be solved, please unplug the power cord immediately and contact your Marantz authorized dealer or service center.
Symptom Cause Solution Page
No power.
The AC power cord is not properly
connected.
Plug the AC power cord fi rmly into
the unit.
6
Plug the AC power plug fi rmly into
a wall outlet.
6
No sound or
distorted sound.
The output cables are not fi rmly
connected.
Connect the output cables fi rmly
into the connectors of this unit and
the amplifi er.
6
The analog outputs of this unit are
connected with the PHONO input
connectors of the amplifi er.
Do not connect the analog outputs
of this unit with the PHONO input
connectors of the amplifi er.
Improper amplifi er operation.
Confi rm the input selection, audio
volume adjustment, and speaker
settings of the amplifi er.
Playback of this unit is paused. Press the Play button. 7
No sound from
the connected
headphones or
distorted sound.
The headphones plug is not fi rmly
connected.
Insert the headphones plug fi rmly
into the headphones jack of this
unit.
4
The headphones level is set to the
minimum.
Adjust the headphones level. 4
No digital audio
output.
The digital connecting cables are
not fi rmly connected.
Securely connect the digital
connecting cables.
8
This unit cannot
be controlled
with the remote
controller.
The batteries of the remote
controller are exhausted.
Replace with new batteries. 3
The remote controller is located
outside its operable range.
Check the operable range of the
remote controller and use it within
that range.
3
Some object is placed between
the unit and remote controller.
Remove the object. 3
The remote sensor of the unit is
exposed to strong light.
Avoid exposing the remote sensor
to the strong light.
3
The EXTERNAL/INTERNAL
switch on the rear panel is set to
EXTERNAL.
Set the EXTERNAL/INTERNAL
switch to INTERNAL.
6
GENERAL
Symptom Cause Solution Page
No playback with
a disc.
The disc is not loaded properly in
the tray.
Load the disc properly. 7
The disc is placed upside-down.
(The label of the disc is facing
down.)
Place the disc with its label facing
upward.
7
The disc is dirty. Clean the disc’s surface. 16
The disc is scratched.
A disc with many scratches may
not be playable.
16
The disc is warped.
The disc may be unable to be
played if it is badly warped.
16
A disc that is not supported by this
unit is attempted to be played.
Use a disc that is supported by
this unit.
14
Condensation has formed on the
lens inside this unit.
Turn on the unit then wait for
about 30 minutes before turning it
back on again and using it.
2
No playback with
a CD-R/CD-RW
disc.
The disc has not been fi nalized.
Perform fi nalization of the disc,
using writing software.
14
The recorded data are not in CDDA
format for music. Or, an MP3/
WMA fi le has not been recorded
properly.
Record data in a proper format
supported by this unit.
14
DISC PLAYBACK