Filter
Top Products
40
English
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, rst check the points listed below before taking the system for repair. If
you are unable to solve a problem by following these instructions, consult your dealer for
help.
No power.
No picture.
Completely distorted picture
or black/white picture.
No sound or distorted sound.
There is no sound from the
center and rear speakers.
– Check if the AC power cord is properly connected.
– Press the 2 (STANDBY ON) to turn on the power.
– Refer to your TV’s manual for correct Video In
channel selection. Change the TV channel until you
see the DVD screen.
– Press the DISC button to select disc mode.
– If this happens when you are turning on the
progressive scan feature, wait for 15 seconds for the
auto recovery.
– If this happens when you are changing the setting of
the ‘TV SYSTEM’, wait for 15 seconds for the auto
recovery.
– Check the video connection.
– Sometimes a small amount of picture distortion may
appear. This is not a malfunction.
– Clean the disc.
– Adjust the volume.
– Check the speaker connections and settings.
– Make sure that the audio cables are connected and
press the SOURCE button to select the correct input
source (for example, TUNER or TV/AUX/DI) to
choose the device that you want to hear through the
DVD system.
– When playback of DTS track,
press AUDIO to select
other audio track.
– Make sure that the center and rear speakers are
connected correctly.
– Press the SURROUND button to select a correct
surround sound setting.
– Make sure that the source you are playing is recorded
or broadcast in surround sound (Dolby Digital, etc.).
Problem (General) Solution