Filter
Top Products
36
English
Tuner Operations
IMPORTANT!
Make sure the FM and AM antennas
are connected.
Tuning to radio stations
A Press SOURCE repeatedly until “FM”
appears on the display panel (or press
TUNER on the remote control).
B Press and hold m / M on the remote
control until the frequency indication
starts to change, then release.
The next radio station will tune
automatically.
C To ne-tune the reception of a weak
station, press m / M brie y and
repeatedly until an optimal reception is
found.
Presetting radio stations
You can store up to 40 preset radio
stations in the memory. There are three
different ways to program the radio
stations:
– Using auto install (for rst time setup
only)
– Using automatic preset
– Using manual preset
Helpful Hints:
– If no radio station is found after searching
from FM to AM band, “CHECK ANTENNA”
appears. Press any keys to exit the tuner
preset mode.
– If you attempt to program more than 40
preset radio stations, “PROGRAM FULL”
appears.
Using auto install
This feature is only applicable for rst
time radio station programming. You will
be prompted to install the radio stations
when you access the tuner mode. With
one touch of button, all the available
radio stations will be stored
automatically.
A Press TUNER.
“AUTO INSTALL PRESS PLAY”
appears.
The system will exit auto install mode
if no button is pressed within 10 seconds
or STOP button is pressed.
B Press u .
“AUTO” appears on the display panel.
The system will start searching from
the FM band followed by the AM band.
All the available radio stations with
strong signal will be stored automatically.
Once complete, the rst preset
station will be played back.