Magnavox FW930R Stereo System User Manual


 
9
English
A AM Loop Antenna
Connection
Connect the supplied loop antenna to the
AM ANTENNA terminal. Place the AM loop
antenna far away from the system and
adjust its position for the best reception.
B FM Wire Antenna
Connection
Connect the supplied FM wire antenna to
the FM ANTENNA 300 terminal. Adjust
the position of the FM antenna for the best
reception.
Outdoor Antenna
For better FM stereo reception, connect an
outdoor FM antenna to the FM ANTENNA
300 terminal using a 300 dipole wire.
C Speakers Connection
Connect the right speaker to Front
terminal R, with the colored wire to +
and the black wire to -.
Connect the left speaker to Front
terminal L, with the colored wire to +
and the black wire to -.
Clip the stripped portion of the speaker
wire as shown.
unlock lock
12 mm
D Subwoofer Out Connection
Connect the optional active subwoofer to
the SUBWOOFER OUT terminal. The
subwoofer reproduces just the low bass
effect (e.g. explosions, the rumble of
spaceships, etc.). Be sure to follow the
instructions supplied with the subwoofer.
E CD Recorder Connections
ANALOG CONNECTIONS
Connect the red plugs to the R sockets, and
the white plugs to the L sockets.
For recording
Connect cable between the ANALOG IN-
sockets on the CD recorder and the LINE
OUT sockets on the mini system, or the
CDR LINE- or TAPE OUT-sockets of an
amplifier.
Note:
For recording directly from a CD player,
the analog input of the CD recorder
should be connected to the analog
output of the CD player.
For playback
Connect cable between the ANALOG OUT-
sockets on the CD recorder and the AUX/
CDR IN sockets on the mini system, or the
input sockets of an amplifier e.g. TAPE IN,
CDR or AUX.
Note:
Never use the PHONO input.
PREPARATION
DIGITAL COAXIAL CONNECTIONS
For recording
Connect the cable between the DIGITAL IN-
socket on the CD recorder and the DIGITAL
OUT-socket on the mini system or CD
player.
For playback
Connect the cable between the DIGITAL
OUT-socket on the CD recorder and the
digital coaxial input of an amplifer or
recording device.
Note:
Digital coaxial connection is only
required in case you wish to record from
a CD player with digital coaxial output.
DIGITAL OPTICAL CONNECTIONS
For recording
Connect a fibre-optic cable
(not supplied)
between the IN OPTICAL of the CD
recorder and the digital-optical output of a
CD player.
Notes:
Digital optical connection is only
required in case you wish to record from
a CD player with digital optical output.
For playback, the digital coaxial output
or analog output should be connected to
an amplifier.
When connecting the Digital Optical
cable, make sure it is fully inserted until
there is a click.
F AC Power Supply
After all other connections have been
made, connect the AC power cord to the
system and to the wall outlet.
Inserting batteries into the
Remote Control
Insert the batteries (Type R06 or AA)
into the remote control as shown in the
battery compartment.
To avoid damage from possible battery
leakage, remove dead batteries or
batteries that will not be used for a long
time. For replacement, use type R06 or
AA batteries.